speed up SATA
Hallo,
I did not get it work with my Maxtor SATA 80GB 6Y080M0.
With 2.6.5-rc2/3 or mm1 no chance to get the higher request size. Is this not possible with the the smaller drives and libata? Im not sure if this disk has the the lba48 feature?
Abit NF7-S with an SilImage 3112a is here under Fedora running.
please cc me,
Marcus
Quoted 3 lines · Marcus Hartig
Hallo,
I did not get it work with my Maxtor SATA 80GB 6Y080M0.
Can you post the relevant 'dmesg' output?
Quoted 3 lines
With 2.6.5-rc2/3 or mm1 no chance to get the higher request size. Is this not possible with the the smaller drives and libata? Im not sure if this disk has the the lba48 feature?
If it does not have lba48, then the patch should print out "request size 128K" or similar.
Quoted 2 lines
Abit NF7-S with an SilImage 3112a is here under Fedora running.
That should be fine with lba48...
Jeff
Quoted 1 line · Jeff Garzik
Can you post the relevant 'dmesg' output?
Linux version 2.6.5-rc3-mm1 (cowboy@redtuxi) (gcc-Version 3.3.3 20040311 (Red Hat Linux 3.3.3-3))
...
Kernel command line: ro root=/dev/sda1 doataraid noraid acpi=off rhgb
...
libata version 1.02 loaded.sata_sil version 0.54
ata1: SATA max UDMA/100 cmd 0xE0800080 ctl 0xE080008A bmdma 0xE0800000 irq 4
ata2: SATA max UDMA/100 cmd 0xE08000C0 ctl 0xE08000CA bmdma 0xE0800008 irq 4
ata1: dev 0 cfg 49:2f00 82:7c6b 83:7b09 84:4003 85:7c69 86:3a01 87:4003 88:207f
ata1: dev 0 ATA, max UDMA/133, 160086528 sectors
ata1: dev 0 configured for UDMA/100
scsi0 : sata_sil
ata2: no device found (phy stat 00000000)
ata2: thread exiting
scsi1 : sata_sil
Vendor: ATA Model: Maxtor 6Y080M0 Rev: 1.02
Type: Direct-Access ANSI SCSI revision: 05
ata1: dev 0 max request 128K
SCSI device sda: 160086528 512-byte hdwr sectors (81964 MB)
SCSI device sda: drive cache: write through
sda: sda1 sda2 sda3 sda4 < sda5 >
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 ------------------%<------------------------------------
Also my Maxtor is now configured for UDMA/100. With earlier versions of libata/sata_sil it was UDMA/133 wo any problems. The performance is now dropped a little bit from ~52MB to ~48MB with hdparm. Best regards,
Marcus