passive LCD support

Good morning,

I'm trying to enable LCD support on my board. It has PXA255, 64M ram and 32 M flash. STN LCD 320x240 (hitachi SX14Q004) is hooked to LCLK, PCLK, FCLK and LDD0-LDD7.

What I did so far:
- in board include set pin settings in pxa registers that are for LCD to AF_2_OUT
- edited board include and added
#define CONFIG_LCD 1
#define CONFIG_HITACHI_SXQ14004 1 /* we
have Hitachi LCD */

- edited pxafb.c and added panel_info (LCD section) between
#ifdef CONFIG_HITACHI_SXQ14004
...
#endif CONFIG_HITACHI_SXQ14004

- provided settings for LCCR0-3 and other LCD regs in pxafb.c

Is this correct approach ?
What else do I need to enable/configure to get LCD working ?
What is the status of pxafb ?

regards, himba

..because under Linux "if something is possible in 
principle,
then it is already implemented or somebody is 
working on it".
							--LKI