Skip to contentSkip to conversation

Interleaved flash chips - basic understanding question

DISCUSSION Oliver Korpilla 1 participant 1 message Apr 26, 2004 Memory technology devices (MTD)

lore
Share & tools
lore
#0 lore raw

Hello!

I have this 4MB of flash device - a Am29LV800BT on my board.

AMD lists the chips as this:

http://www.amd.com/us-en/FlashMemory/ProductInformation/0,,37_1447_1623_1468%5E1532,00.html

These devices are 16-Bit accessible, mine is 64-bit accessible.

My device is 4 MB = 32 M-Bit = 4 * 8 M-Bit => consists of 4 of these chips listed above, I guess.

And the bigger erase regions on the single devices are 64KB, and mine are 4*64 KB= 256 KB

If I understand this right, with a serial setup two flash chips simply have an address space double as long with the same access width.

My device is interleaved, so if I write a 64-bit date is it actually distributed like this - 16 Bit into 1st chip, 16 Bit into 2nd, ... ??? And if I erase the 1st region on my device, are then all the 4 first regions erased??

Am I understanding this right?

Am I required to access a 64-bit-width interleaved flash in 64-bit wide accesses or can I use "smaller" ones (8, 16, 32 bit)??

Now how to configure the device? How can I make it work, if the driver seems to be broken (cfi_cmdset_0002.c v 1.62, v 1.93 and v 1.98 don't seem to work)? (If I set width in octetts, as configurable in 2.4.25, to 8 this doesn't even compile, but 4 does)

Thanks in advance,
Oliver Korpilla