Skip to contentSkip to conversation

Bestcomm on mpc5200

DISCUSSION Pestka Christophe 2 participants 2 messages Jul 21, 2004

lore
Share & tools
lore
#1 lore raw
In reply to Pestka Christophe
Quoted 4 lines · In message <[email protected]> you wrote:

I ' ve seen there is a Bestcomm API on the ELDK from Denx for the
mpc5200, but I don' t know how can I use it on a linux system.
Is someone has ever used it, or an example to give me?

See how is used by the Linux device drivers - I'm not sure if this will serve as a good example or a bad one, though ;-)

On the CVS server there is also arch/ppc/5xxx_io/bestcomm/doc/BestCommAPIUserGuide.pdf

Best regards,

Wolfgang Denk

--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] Computers are not intelligent. They only think they are.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#0 lore raw

Hi,

I ' ve seen there is a Bestcomm API on the ELDK from Denx for the
mpc5200, but I don' t know how can I use it on a linux system.
Is someone has ever used it, or an example to give me?

Best regards,

Pes.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/