Skip to contentSkip to conversation

network scripts debian

LARTC John McMonagle 2 participants 2 messages Aug 3, 2004 – Aug 5, 2004

lore
Share & tools
lore
#0 lore raw

Working at setting up some new firewalls with multi-path routing over 2 isps. Doing it with debian sarge.

Problem is the normal network scripts use ifconfig and route.

In my tests I did a simple setup script.

Feel like I am reinventing the wheel :-)

Is it OK to use the network scripts to setup the interface and then remove the routes ifconfig created and add any needed routes with ip commands?

Or am I best setting up the connections from scratch?

Also related is some of interfaces are dynamic. I ran rewrite dhclient-script or just rebuild routes in dhclient-exit-hooks.d.

Also dhcpd-script gives
new_subnet_mask=.........
new_ip_address=....
new_network_number=......
interface=eth2

But for ip route need the length part of new_network_number/length

Is there a simple way to calculate length from new_subnet_mask ?

Thanks

John
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 7 lines · John McMonagle

Working at setting up some new firewalls with multi-path routing over 2 isps. Doing it with debian sarge.

Problem is the normal network scripts use ifconfig and route.

In my tests I did a simple setup script.

Quoted 7 lines

Feel like I am reinventing the wheel :-)

Is it OK to use the network scripts to setup the interface and then remove the routes ifconfig created and add any needed routes with ip commands?

Or am I best setting up the connections from scratch?

After struggling with exactly this same issue myself, I simply created everything from scratch. Otherwise, I couldn't ever get it to work.

Quoted 10 lines

Also related is some of interfaces are dynamic. I ran rewrite dhclient-script or just rebuild routes in dhclient-exit-hooks.d.

Also dhcpd-script gives
new_subnet_mask=.........
new_ip_address=....
new_network_number=......
interface=eth2

Quoted 3 lines

But for ip route need the length part of new_network_number/length

Is there a simple way to calculate length from new_subnet_mask ?

dunno about that one.

Glen

Signature · 8 lines
******************************************************************
Glen W. Mabey
[email protected]
http://mabeys.homelinux.com/glen/
******************************************************************
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/