Skip to contentSkip to conversation

delkin_cb: new carbus IDE driver

PATCH RESEND In review Mark Lord 2 participants 2 messages Oct 26, 2004

Subsystems (4)
Documentation SCSI PCI Ninja SCSI-32Bi/ude PCI/cardbus SCSI host adapter driver
lore
Share & tools
lore

Mark Lord

author
#0 lore raw

PATCH RESEND 1/1 delkin_cb: new carbus IDE driver

Marcelo,

This new driver is also ready to go into 2.4.xx. It is completely stand-alone, with no code impact to any existing drivers, and so should be pretty safe.

Changes since last posting: fixed handling of module load errors.

Signed-off-by Mark Lord <[email protected]>
Signature · 2 lines
Mark Lord
(hdparm keeper & the original "Linux IDE Guy")
Documentation/Configure.help +7 -0
diff -u --recursive --new-file --exclude='.*' linux-2.4.28-pre4-bk6/Documentation/Configure.help linux/Documentation/Configure.help
@@ -781,6 +781,13 @@
   <file:Documentation/modules.txt>. The module will be called
   ide-cs.o
 
+Cardbus IDE support (Delkin/ASKA/Workbit)
+CONFIG_BLK_DEV_DELKIN
+  Support for Delkin/ASKA/Workbit cardbus CompactFlash Adapters.
+  This may also work for similar SD and XD adapters.  If you want
+  to be able to use one of these, then say M here.  The module will
+  be called delkin_cb.o
+
 Include IDE/ATAPI CD-ROM support
 CONFIG_BLK_DEV_IDECD
   If you have a CD-ROM drive using the ATAPI protocol, say Y. ATAPI is
drivers/ide/Config.in +1 -0
diff -u --recursive --new-file --exclude='.*' linux-2.4.28-pre4-bk6/drivers/ide/Config.in linux/drivers/ide/Config.in
@@ -18,6 +18,7 @@
    dep_mbool '    Auto-Geometry Resizing support' CONFIG_IDEDISK_STROKE $CONFIG_BLK_DEV_IDEDISK
 
    dep_tristate '  PCMCIA IDE support' CONFIG_BLK_DEV_IDECS $CONFIG_BLK_DEV_IDE $CONFIG_PCMCIA
+   dep_tristate '  Cardbus IDE support (Delkin/ASKA/Workbit)' CONFIG_BLK_DEV_DELKIN $CONFIG_BLK_DEV_IDE $CONFIG_PCMCIA $CONFIG_PCI
    dep_tristate '  Include IDE/ATAPI CDROM support' CONFIG_BLK_DEV_IDECD $CONFIG_BLK_DEV_IDE
    dep_tristate '  Include IDE/ATAPI TAPE support' CONFIG_BLK_DEV_IDETAPE $CONFIG_BLK_DEV_IDE
    dep_tristate '  Include IDE/ATAPI FLOPPY support' CONFIG_BLK_DEV_IDEFLOPPY $CONFIG_BLK_DEV_IDE
drivers/ide/pci/delkin_cb.c +149 -0

149 lines not on this page · raw message

drivers/ide/pci/Makefile +1 -0
diff -u --recursive --new-file --exclude='.*' linux-2.4.28-pre4-bk6/drivers/ide/pci/Makefile linux/drivers/ide/pci/Makefile
@@ -34,6 +34,7 @@
 obj-$(CONFIG_BLK_DEV_TRM290)		+= trm290.o
 obj-$(CONFIG_BLK_DEV_VIA82CXXX)		+= via82cxxx.o
 obj-$(CONFIG_BLK_DEV_TRIFLEX)		+= triflex.o
+obj-$(CONFIG_BLK_DEV_DELKIN)		+= delkin_cb.o
 
 # Must appear at the end of the block
 obj-$(CONFIG_BLK_DEV_GENERIC)		+= generic.o
drivers/scsi/nsp32.h +0 -1
diff -u --recursive --new-file --exclude='.*' linux-2.4.28-pre4-bk6/drivers/scsi/nsp32.h linux/drivers/scsi/nsp32.h
@@ -22,7 +22,6 @@
  * VENDOR/DEVICE ID
  */
 #define PCI_VENDOR_ID_IODATA  0x10fc
-#define PCI_VENDOR_ID_WORKBIT 0x1145
 
 #define PCI_DEVICE_ID_NINJASCSI_32BI_CBSC_II   0x0005
 #define PCI_DEVICE_ID_NINJASCSI_32BI_KME       0xf007
include/linux/pci_ids.h +3 -0
diff -u --recursive --new-file --exclude='.*' linux-2.4.28-pre4-bk6/include/linux/pci_ids.h linux/include/linux/pci_ids.h
@@ -2057,3 +2057,6 @@
 #define PCI_DEVICE_ID_MICROGATE_USC	0x0010
 #define PCI_DEVICE_ID_MICROGATE_SCC	0x0020
 #define PCI_DEVICE_ID_MICROGATE_SCA	0x0030
+
+#define PCI_VENDOR_ID_WORKBIT		0x1145
+#define PCI_DEVICE_ID_WORKBIT_CB	0xf021
#1 lore raw
Quoted 5 lines · Mark Lord

Marcelo,

This new driver is also ready to go into 2.4.xx. It is completely stand-alone, with no code impact to any existing drivers, and so should be pretty safe.

Ok I buy that, applied.

Thanks.

Quoted 6 lines

Changes since last posting: fixed handling of module load errors.

Signed-off-by Mark Lord <[email protected]>
Signature · 2 lines
Mark Lord
(hdparm keeper & the original "Linux IDE Guy")