porting u-boot
I'm still into porting u-boot to a full-custom board.
The u-boot README says that the u-boot will scan for my SDRAM and find out how much I have.
I suppose that will only work if I write a custom SDRAM-setup-procedure ..../u-boot/board/CUSTOMBOARD/customboard.c ? Is that right?
If so, is there any documentation about what needs to be done there? I believe that the sdram_table array used in all those board_name.c files contains hexadecimal encoded instructions programming the UPM.. am I right?
Well... any hints (like, for example, "RTFM manual/ressource name") are welcome.
Peter Asemann
Quoted 3 lines · In message <[email protected]> you wrote:
I suppose that will only work if I write a custom SDRAM-setup-procedure
..../u-boot/board/CUSTOMBOARD/customboard.c? Is that right?
You cannot avoid this, right (you need it even if you set up for a fixed memory size only).
Quoted 1 line
If so, is there any documentation about what needs to be done there?
Sure. See the processor's User's manual and related documentation.
Quoted 2 lines
Well... any hints (like, for example, "RTFM manual/ressource name") are welcome.
Here we go: RTFM the processor documentation and related material ;-)
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Too much of anything, even love, isn't necessarily a good thing. -- Kirk, "The Trouble with Tribbles", stardate 4525.6