MX1ADS board
Dear all
I am using CVS u-boot on mx1ads with syncflash. But i found that the
default board config load the kernel from 0x8800 0000, which is ram address.
What i am going to do is to port u-boot to MXL platform with AMD NOR
flash, Do anyone try that before?
Also, i see that there is usbtty on OMAP platform, MX1/MXL is also
embedded a usb1.1 client port. Could anyone please tell me how to start to port on MX1/MXL? or anyone try that before?
I am new to this place, if i make any things wrong, please tell me. Thanks for helping
best regard
Mike,Lee
Dear mike,
Quoted 3 lines
I am using CVS u-boot on mx1ads with syncflash. But i found that the
default board config load the kernel from0x88000000, which is ram address.
So what? Of course $loadaddr should be in RAM. What exactly is your problem?
Quoted 2 lines
What i am going to do is to port u-boot to MXL platform with AMD NOR
flash, Do anyone try that before?
Sure.
Quoted 1 line
I am new to this place, if i make any things wrong, please tell me.
Welcome! But yes, we will! ;-)
Just make sure to RTFM first.
--
Steven