Skip to contentSkip to conversation

2.6.10 IDE lockups

DISCUSSION Eyal Lebedinsky 1 participant 1 message Jan 6, 2005

lore
Share & tools
lore
#0 lore raw

I am trying to figure out if this is a problem with my system or a kernel issue.

The symptom is that an IDE disk reports a DMA problem and then the machine locks up hard (not even SysRq).

I ran an overnight memcheck and all was well.

Now, I cannot blame the software outright because a second disk (hdb) was added about the time the problems started. Either the disk is at fault or it just provoked a real software bug.

The new hdb is used strictly for mythtv, and looking at the latest crash I can say with confidence that hdb had no activity. It died at 09:20:01 and I was, naturally, still sleeping happily at the time. Mythtv had no active clients and the log shows an idle server. BTW, I has a 'sync' done every 10s to reduce the damage, but I expect it had nothing to write to hdb.

I had lockups where hda reported an errors, and others where hdb reported the error.

This showed up with 2.6.10, -ac3, -mm1 and -rc3-mm1. At times I could even see an oops. Here are some snippets. How should I proceed with the investigation?

Boot log
========
hda: status timeout: status=0x80 { Busy }
ide: failed opcode was: unknown
hda: DMA disabled
hdb: DMA disabled
hda: drive not ready for command
ide0: reset: success

and the system went on without DMA.

serial console
==============
hda: dma_timer_expiry: dma status == 0x61
hda: DMA timeout error

And the machine is dead. I saw this one most of the time

An unusual boot log with 2.6.10-rc3-mm1
===================

------------[ cut here ]------------
PREEMPT SMP
Modules linked in: ichxrom mtdcore chipreg map_funcs ehci_hcd usb_storage scsi_mod uhci_hcd usbcore shpchp pci_hotplug intel_mch_agp intel_agp agpgart parport_pc parport evdev nls_cp437 msdos fat dm_mod rtc unix
CPU:    0
EIP:    0060:[__change_page_attr+412/425]    Not tainted VLI
EFLAGS: 00010002   (2.6.10-rc3-mm1)

EIP is at __change_page_attr+0x19c/0x1a9
eax: ffffffff ebx: c2ff6000 ecx: c2ff6000 edx: 00000246
esi: 00000000 edi: 00000173 ebp: 00000246 esp: c3dcbf0c
ds: 007b es: 007b ss: 0068
Process modprobe (pid: 2601, threadinfo=c3dcb000 task=f7b71a60)

Stack: 00000000 00500000 ffb00000 c2ff6000 00000000 00000000 00000246 c0116254         c2ff6000 00000173 ffb00000 f8a80000 00500000 c3dcb000 c0115dbd c2ff6000
       00000500 00000173 c19f0000 00000000 c3dcbf7f f880e2cd ffb00000 00500000
Call Trace:
 [change_page_attr+71/92] change_page_attr+0x47/0x5c
 [ioremap_nocache+147/170] ioremap_nocache+0x93/0xaa
 [pg0+943305421/1069069312] ichxrom_init_one+0x1a4/0x580 [ichxrom]
 [pci_find_device+47/51] pci_find_device+0x2f/0x33
 [pg0+944808020/1069069312] init_ichxrom+0x54/0x56 [ichxrom]
 [sys_init_module+367/542] sys_init_module+0x16f/0x21e
 [syscall_call+7/11] syscall_call+0x7/0xb
Code: fc fe ff ff 80 3e 00 78 15 29 d3 c1 fb 05 c1 e3 0c 09 fb 89 1e f0 ff 49 04 e9 f5 fe ff ff 0f 0b 82 00 44 4e 2d c0 e9 e8 fe ff ff <0f> 0b 6c 00 44 4e 2d c0 e9 71 fe ff ff 55 b8 18 b8 30 c0 57 31
 <6>note: modprobe[2601] exited with preempt_count 1
 [schedule+2904/2909] schedule+0xb58/0xb5d
 [zap_pgd_range+70/98] zap_pgd_range+0x46/0x62
 [cond_resched+39/60] cond_resched+0x27/0x3c
 [unmap_vmas+388/661] unmap_vmas+0x184/0x295
 [exit_mmap+165/400] exit_mmap+0xa5/0x190
 [mmput+67/246] mmput+0x43/0xf6
 [do_exit+424/1333] do_exit+0x1a8/0x535
 [do_trap+0/272] do_trap+0x0/0x110
 [do_invalid_op+0/195] do_invalid_op+0x0/0xc3
 [do_invalid_op+174/195] do_invalid_op+0xae/0xc3
 [buffered_rmqueue+294/586] buffered_rmqueue+0x126/0x24a
 [__change_page_attr+412/425] __change_page_attr+0x19c/0x1a9
 [__alloc_pages+596/1033] __alloc_pages+0x254/0x409
 [smp_call_function+196/272] smp_call_function+0xc4/0x110
 [__get_free_pages+51/63] __get_free_pages+0x33/0x3f
 [error_code+43/48] error_code+0x2b/0x30
 [__change_page_attr+412/425] __change_page_attr+0x19c/0x1a9
 [change_page_attr+71/92] change_page_attr+0x47/0x5c
 [ioremap_nocache+147/170] ioremap_nocache+0x93/0xaa
 [pg0+943305421/1069069312] ichxrom_init_one+0x1a4/0x580 [ichxrom]
 [pci_find_device+47/51] pci_find_device+0x2f/0x33
 [pg0+944808020/1069069312] init_ichxrom+0x54/0x56 [ichxrom]
 [sys_init_module+367/542] sys_init_module+0x16f/0x21e
 [syscall_call+7/11] syscall_call+0x7/0xb

But the machine continued the boot to completion.

Signature · 2 lines
Eyal Lebedinsky ([email protected]) <http://samba.org/eyal/>
	If attaching .zip rename to .dat