ServerWorks CSB6 DMA problems
Hi all,
is anyone aware of the status of ServerWorks CSB6's chipset DMA support?
On a machine with a RHEL3 kernel (2.4.21-27.0.1.EL), the kernel seems to enable UDMA33 on the first connected disk (Seagate 7200.7) but uses PIO mode on the second (Maxtor 6Y080P0).
I found out this is for good reasons because after enabling UDMA100 on both disks, via hdparm, filesystem corruption quickly resulted.
Googling turns up a lot of talk about buggy CSB4 chipsets, but nothing about the CSB6, actually several posts claiming it should work ok. The above experience and the kernel's selection suggest that's not the whole story though.
Basically, I'm curious if there's any *safe* way to get some more performance out of this configuration on Linux, or if I'm SOL. I mean, the Maxtor in PIO mode works at about 2Mb/s... :-/
Signature · 1 line
GCP
Quoted 6 lines · Gian-Carlo Pascutto
On a machine with a RHEL3 kernel (2.4.21-27.0.1.EL), the kernel seems to enable UDMA33 on the first connected disk (Seagate 7200.7) but uses PIO mode on the second (Maxtor 6Y080P0).
I found out this is for good reasons because after enabling UDMA100 on both disks, via hdparm, filesystem corruption quickly resulted.
That all suprises me a great deal, although the modes are normally BIOS selected by the Serverworks and then read by the kernel. CBS5/CSB6 IDE should be very reliable indeed (OSB4 is a much older chipset and the problem it has is OSB4 specific)
I'd also suggest you raise it with your RHEL support and/or bugzilla.redhat.com
Alan