8250 FCC in half-duplex mode transmit timed out
hello again,
after few month of silence, i found this group here :) thx for getting it back to live
i have new problem with 8250 FCC in ethernet mode,
it works fine in FDX, but after some time of heavy transmit all BD-s become busy
the only way to continue is to reset FCC, but ituation repeats after 10-30 seconds
any sollution?
i've tried out CPM11,CPM112 and CPM119 microcode pathes from freescale, no success with this stuff
by the way: does anyone know how to apply muiltiple patches at same time?
<cut>
no answer?
so, i have one smiple question:
does anyone tried to make huge traffic from 82xx conneted to hub (not to switch, to force half duplex mode) ???
ps: my results of getting large file via ftp are described in previous mail