Skip to contentSkip to conversation

skge no workee here

DISCUSSION maxer 2 participants 2 messages Feb 6, 2005

Subsystems (2)
lore
Share & tools
lore

maxer

author
#0 lore raw

Jgarzik wanted me to forward this to you today.

This nic is on the mobo. sk98lin from kernel 2.6.9 works great. However:

If I go into Fedora Core's Network Device Control applet, it shows eth0 inactive. If I try to activate it I get:
skge device eth0:1 does not seem to be present, delaying initialization.

Under Network Configuration tool trying to probe under "Bind to MAC address gives the result as [Errno 19] No such device.

So while the driver clearly loads, it can't find the device nor activate it.

What should I do to remedy this. I can bring up the device under kernel 2.6.9, but no kernel beyond this 2.6.10 or 2.6.11-xx works.

04:00.0 Ethernet controller: Marvell Technology Group Ltd. Gigabit Ethernet Controller (rev 17)
Subsystem: Intel Corp.: Unknown device 3065
Flags: bus master, fast devsel, latency 0, IRQ 3
Memory at ff720000 (64-bit, non-prefetchable) [size=16K]
I/O ports at a800 [size=256]
Expansion ROM at ff700000 [disabled] [size=128K]
Capabilities: [48] Power Management version 2
Capabilities: [50] Vital Product Data
Capabilities: [5c] Message Signalled Interrupts: 64bit+ Queue=0/1
Enable-
Capabilities: [e0] Express Legacy Endpoint IRQ 0
Capabilities: [100] Advanced Error Reporting

Thanks,

RaXeT

#1 lore raw

maxer <[email protected]> :
[...]

Interesting.

Can you send dmesg/config for the working 2.6.9 kernel and the dysfunctional 2.6.10 ?

The brand of the motherboard would be welcome too.

--
Ueimor