Stephen
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 16 lines · On Thu, 24 Feb 2005 15:26:43 -0700 Bryan Waters <[email protected]> wrote:
I'm trying to debug my bridge...i've sent an email to the list but i'm not yet approved by the moderator. Can you help me?
thx
-bryanw---------------------------------- Email to Bridge Mailing List
-----------------------------------------
I've got a 2.6.8 kernel with bridging enabled as a module, two nics (LNE100TX and RTL8139) and i've run the following commands with no errorsmodprobe -v bridge
brctl addbr br0
brctl addif br0 eth0
brctl addif br0 eth1
Quoted 4 lines
both interfaces have 0.0.0.0 as their addresses and brctl showmacs br0 shows the macs for both internal cards. However, bridging doesn't seem to be working at all. What am I missing or what else can I try to debug what might be wrong?
Are the eth0, eth1 marked as up? also it takes a while for the spanning tree timers to go from learning to forwarding state. Look at brctl show stp br0