64bit compile of tulip driver
Under 32bit the tulip driver works fine, but under 64 bit it gives me a lot of grief.
First off it continually sends data out the network interface and never negotiates is speed and duplex. Second in the log files all I see is an uninformative message 0000:00:07.0: tulip_stop_rxtx() failed
Here is all the bootup information differences I can find on the driver 64 bit
Dec 31 16:01:29 lfs tulip0: ***WARNING***: No MII transceiver found! Dec 31 16:01:29 lfs tulip1: ***WARNING***: No MII transceiver found! 32 bit Dec 31 16:01:16 lfs tulip0: MII transceiver #1 config 1000 status 7809 advertising 01e1 Dec 31 16:01:16 lfs tulip1: MII transceiver #1 config 1000 status 7809 advertising 01e1.
Complete boot log
Under a 64 bit compile
Dec 31 16:01:29 lfs Linux Tulip driver version 1.1.13 (May 11, 2002) Dec 31 16:01:29 lfs PCI: Enabling device 0000:00:07.0 (0045 -> 0047) Dec 31 16:01:29 lfs tulip0: Old format EEPROM on 'Cobalt Microserver' board. Using substitute media control info. Dec 31 16:01:29 lfs tulip0: EEPROM default media type Autosense. Dec 31 16:01:29 lfs tulip0: Index #0 - Media MII (#11) described by a 21142 MII PHY (3) block. Dec 31 16:01:29 lfs tulip0: ***WARNING***: No MII transceiver found! Dec 31 16:01:29 lfs eth0: Digital DS21143 Tulip rev 65 at ffffffffb0001400, 00:10:E0:00:32:DE, IRQ 19. Dec 31 16:01:29 lfs PCI: Enabling device 0000:00:0c.0 (0005 -> 0007) Dec 31 16:01:29 lfs tulip1: Old format EEPROM on 'Cobalt Microserver' board. Using substitute media control info. Dec 31 16:01:29 lfs tulip1: EEPROM default media type Autosense. Dec 31 16:01:29 lfs tulip1: Index #0 - Media MII (#11) described by a 21142 MII PHY (3) block. Dec 31 16:01:29 lfs tulip1: ***WARNING***: No MII transceiver found! Dec 31 16:01:29 lfs eth1: Digital DS21143 Tulip rev 65 at ffffffffb0001480, 00:10:E0:00:32:DF, IRQ 20. Dec 31 16:01:29 lfs bootlog: Bringing up the eth0 interface...[ OK ] Dec 31 16:01:30 lfs bootlog: Adding IPv4 address 172.16.0.99 to the eth0 interface...[ OK ] Dec 31 16:01:31 lfs bootlog: Setting up default gateway...[ OK ] Dec 31 16:01:32 lfs 0000:00:07.0: tulip_stop_rxtx() failed Dec 31 16:01:38 lfs 0000:00:07.0: tulip_stop_rxtx() failed Dec 31 16:01:44 lfs 0000:00:07.0: tulip_stop_rxtx() failed Dec 31 16:01:50 lfs 0000:00:07.0: tulip_stop_rxtx() failed Dec 31 16:01:56 lfs 0000:00:07.0: tulip_stop_rxtx() failed Dec 31 16:02:02 lfs 0000:00:07.0: tulip_stop_rxtx() failed Dec 31 16:02:08 lfs 0000:00:07.0: tulip_stop_rxtx() failed Dec 31 16:02:12 lfs bootlog: Setting time via pool.ntp.org...[ FAIL ]
Under 32 bit
Dec 31 16:01:16 lfs Linux Tulip driver version 1.1.13 (May 11, 2002) Dec 31 16:01:16 lfs PCI: Enabling device 0000:00:07.0 (0045 -> 0047) Dec 31 16:01:16 lfs tulip0: Old format EEPROM on 'Cobalt Microserver' board. Using substitute media control info. Dec 31 16:01:16 lfs tulip0: EEPROM default media type Autosense. Dec 31 16:01:16 lfs tulip0: Index #0 - Media MII (#11) described by a 21142 MII PHY (3) block. Dec 31 16:01:16 lfs tulip0: MII transceiver #1 config 1000 status 7809 advertising 01e1. Dec 31 16:01:16 lfs eth0: Digital DS21143 Tulip rev 65 at b0001400, 00:10:E0:00:32:DE, IRQ 19. Dec 31 16:01:16 lfs tulip1: Old format EEPROM on 'Cobalt Microserver' board. Using substitute media control info. Dec 31 16:01:16 lfs tulip1: EEPROM default media type Autosense. Dec 31 16:01:16 lfs tulip1: Index #0 - Media MII (#11) described by a 21142 MII PHY (3) block. Dec 31 16:01:16 lfs tulip1: MII transceiver #1 config 1000 status 7809 advertising 01e1. Dec 31 16:01:16 lfs eth1: Digital DS21143 Tulip rev 65 at b0001480, 00:10:E0:00:32:DF, IRQ 20. Dec 31 16:01:17 lfs bootlog: Bringing up the eth0 interface...[ OK ] Dec 31 16:01:17 lfs bootlog: Adding IPv4 address 172.16.0.99 to the eth0 interface...[ OK ] Dec 31 16:01:18 lfs bootlog: Setting up default gateway...[ OK ] Dec 31 16:01:20 lfs eth0: Setting full-duplex based on MII#1 link partner capability of 45e1. Mar 28 08:27:35 lfs bootlog: Setting time via pool.ntp.org...[ OK ] Mar 28 08:27:35 lfs syslog-ng[1457]: STATS: dropped 0
Signature · 3 lines
---- Jim Gifford [email protected]
On Tue, 2005-03-29 11:01:02 -0800, Jim Gifford <[email protected]> wrote in message <[email protected]>:
Quoted 10 lines
Under 32bit the tulip driver works fine, but under 64 bit it gives me a lot of grief.
First off it continually sends data out the network interface and never negotiates is speed and duplex.
Second in the log files all I see is an uninformative message 0000:00:07.0:tulip_stop_rxtx()failedHere is all the bootup information differences I can find on the driver 64 bit
Quoted 7 lines
Dec 31 16:01:29 lfs tulip0: ***WARNING***: No MII transceiver found! Dec 31 16:01:29 lfs tulip1: ***WARNING***: No MII transceiver found! 32 bit Dec 31 16:01:16 lfs tulip0: MII transceiver #1 config 1000 status 7809 advertising 01e1 Dec 31 16:01:16 lfs tulip1: MII transceiver #1 config 1000 status 7809advertising 01e1.
That's all wrongly wrapped around. However, where's the patch?
MfG, JBG
Signature · 4 lines
Jan-Benedict Glaw [email protected] . +49-172-7608481 _ O _ "Eine Freie Meinung in einem Freien Kopf | Gegen Zensur | Gegen Krieg _ _ O fuer einen Freien Staat voll Freier Bürger" | im Internet! | im Irak! O O O ret = do_actions((curr | FREE_SPEECH) & ~(NEW_COPYRIGHT_LAW | DRM | TCPA));