how to add CR to printf message automatically?
Dear u-boot community,
I am now porting u-boot to my own evaluation board. The UART functions now.
However, the printed messages on hyper-terminal are lacks of "CR" character. Most messages in u-boot is only ends with "\n".
How to let printf() automatically add "\r" at the end of messages?
Thanks.
Wayne
Quoted 2 lines · In message <[email protected]> you wrote:
However, the printed messages on hyper-terminal are lacks of "CR" character.
Intall an operating system on your host, or at least a decent terminal program.
Quoted 1 line
Most messages in u-boot is only ends with "\n".
No. The output routines translate each '\n' character into a 'r' + '\n' sequence.
Quoted 1 line
How to let
printf()automatically add "\r" at the end of messages?
You don't. This already gets done in the serial driver code.
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Xerox never comes up with anything original.