How to use -v option in mkimage?
yongdae
How to use -v option in mkimage?
In mkimage.c, 'v' parameter increase to 'vflag' value.
I don't know that's mean.
For adding image?
Please talk to me..
Quoted 1 line · In message <[email protected]> you wrote:
How to use -v option in mkimage?
You use it by adding it to the command line, or by omitting it.
Quoted 3 lines
In
mkimage.c, 'v' parameter increase to 'vflag' value.I don't know that's mean.
Well, if you looked *this* up in the source code, why didn't you also look up where vflag is referenced in the code?
Like in so many other tools "-v" meand "verbose". In mkimage, there is not much verbosity added, though.
Best regards,
Wolfgang Denk
Signature · 5 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de : I've tried (in vi) "g/[a-z]\n[a-z]/s//_/"...but that doesn't : cut it. Any ideas? (I take it that it may be a two-pass sort of solution). In the first pass, install perl. :-) Larry Wall <[email protected]>