Skip to contentSkip to conversation

forcedeth as a module only?

DISCUSSION Christian Kujau 1 participant 1 message Jun 17, 2005

lore
Share & tools
lore
#0 lore raw

hi,

are there any known issues with the forcedeth driver when statically compiled in? i have an onboard GbE ethernet controller (see below) and forcedeth seems to work pretty fine for this controller. it's 100Mbps only, but i don't care because my switch is 100Mbps too.

i've noticed that the driver just does not work, when it's compiled with CONFIG_FORCEDETH=y

eth0: forcedeth.c: subsystem: 01462:0250 bound to 0000:00:05.0
eth0: no link during initialization

recompiling the same kernel (2.6.12-rc6-mm1, x86_64) with CONFIG_FORCEDETH=m and loading the module without any parameters get the NIC up. mii-tool does not work in both cases, CONFIG_MII is set to "y".

any hints?

thank you,
Christian.

% lspci -v | grep -A6 0000:00:05.0
0000:00:05.0 Bridge: nVidia Corporation: Unknown device 00df (rev a2)
Subsystem: Micro-Star International Co., Ltd.: Unknown device 0250
Flags: bus master, 66MHz, fast devsel, latency 0, IRQ 217 Memory at f8000000 (32-bit, non-prefetchable) [size=4K] I/O ports at d800 [size=8]
Capabilities: [44] Power Management version 2

(the manual says it's a Marvell 88E111 10/100/1000 onboard NIC)

% mii-tool
SIOCGMIIPHY on 'eth0' failed: Operation not supported SIOCGMIIPHY on 'eth1' failed: Operation not supported no MII interfaces found

% ethtool eth0
Settings for eth0:
Supported ports: [ MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: externel
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Link detected: yes

Signature · 3 lines
BOFH excuse #334:

50% of the manual is in .pdf readme files