Skip to contentSkip to conversation

[Fwd: Re: Nand Flash driver for dedicated conroller]

Fwd: Re: Nand Flash driver for dedicated conroller Ajay Jain 2 participants 2 messages Jul 15, 2005 Memory technology devices (MTD)

lore
Share & tools
lore

Ajay Jain

author
#0 lore raw
Quoted 13 lines
Quoted 13 lines
Quoted 6 lines · Sunil Khandelwal

I have an ARM based board, which has a flash
controller on chip.

There is no way I can control the signals like

Quoted 6 lines
Quoted 6 lines

ALE, CE

Quoted 3 lines

etc to flash directly.

Hi,

Even I have a similar problem, our flash controller does not allow us to control ALE, CLE etc, and the nand layer in mtd assumes that such a control is available. Our sandisk controller has exposed certain commands like Read, Write, Block Erase etc and it is does not allow any access to ALE. How can I use the current code to incorporate the controller.

Ajay

Quoted 2 lines
#1 lore raw

Why is it that even after being referred to
http://david.woodhou.se/email.html you persist in posting this kind of crap?

Look at your message -- http://david.woodhou.se/badmail1.jpeg

You leave blank lines at the top, you have an utterly unreadable mess where you wrongly word-wrap the message to which you're replying, and you have _more_ lines containing just '>>>' than actual text.

And then you add more lines of your own, which are far more than the accepted norm of 76 characters each.

To top it all, you forward a message which had already been rejected once, so it isn't even part of the correct thread.

Compare with what your mail _should_ have looked like, at
http://david.woodhou.se/badmail-fixed.jpeg

I have asked you nicely once to conform to common netiquette, yet you are still being lazy and rude. Keep it up and you will be barred from the list.

Signature · 1 line
dwmw2