Skip to contentSkip to conversation

some feedback with kernel 2.6.12 FC4

Bridge Stephen Hemminger 1 participant 1 message Jul 22, 2005 1 message not in the archive Ethernet bridge

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive
Quoted 9 lines · On Thu, 21 Jul 2005 16:54:06 +0200 Christophe GRANSART…

Hello,

Some feedback about bridge-utils on FC4 :

i tried bridge-utils 1.0.4 and 1.0.6 on FC4 2.6.12-1.1398_FC4 On a dell D800
With eth0 : Broadcom NetXtreme BCM5705M Gigabit Ethernet and ath0 : DLink DWL-AG650 driver madwifi

Quoted 8 lines

On both 1.0.4 and 1.0.6, my system freezes after 30 - 60 sec after the bridge is up (even with promisc mode on both ath0 and eth0).

When eth0 and ath0 are up, they are both on irq 11. Is this a parameter to change?

Regards,
Christophe

It is almost certainly not a utilities issue. The command does almost nothing but setup the bridge. Most times when whole system freezes, it is a panic. If you are running X windows the kernel is unable to display output, so you either need to add a serial console (and another system to capture the output) or the virtual terminal 0 console to avoid X running (ALT-F1).