8139cp: Catch all interrupts
Subsystems (2)
PATCH 1/1 8139cp: Catch all interrupts
Register interrupt handler when net device is registered. Avoids missing interrupts if the interrupt mask gets out of sync.
---
The reason this patch is needed for me is that the resume function is broken. It enables interrupts unconditionally, but the interrupt handler is only registered when the device is up.
I don't have enough knowledge about the driver to fix the resume function so this patch will instead make sure that the interrupt handler is registered at all times (which can be a nice safeguard even when the resume function gets fixed).
drivers/net/8139cp.c +7 -10
@@ -1204,20 +1204,11 @@cp_init_hw (cp); - rc =request_irq (dev->irq, cp_interrupt,SA_SHIRQ , dev->name, dev); -if (rc) - goto err_out_hw; -netif_carrier_off (dev);mii_check_media (&cp->mii_if,netif_msg_link (cp), TRUE);netif_start_queue (dev);return 0 ; - -err_out_hw: -cp_stop_hw (cp); -cp_free_rings (cp); -return rc; }static int cp_close (struct net_device *dev)
@@ -1238,7 +1229,6 @@spin_unlock_irqrestore (&cp->lock, flags);synchronize_irq (dev->irq); -free_irq (dev->irq, dev);cp_free_rings (cp);return 0 ;
@@ -1813,6 +1803,10 @@if (rc) goto err_out_iomap; + rc =request_irq (dev->irq, cp_interrupt,SA_SHIRQ , dev->name, dev); +if (rc) + goto err_out_unreg; + printk (KERN_INFO "%s: RTL-8139C+ at 0x%lx, " "%02x:%02x:%02x:%02x:%02x:%02x, " "IRQ %d\n",
@@ -1832,6 +1826,8 @@return 0 ; +err_out_unreg: +unregister_netdev (dev); err_out_iomap:iounmap (regs); err_out_res:
@@ -1852,6 +1848,7 @@if (!dev)BUG (); +free_irq (dev->irq, dev);unregister_netdev (dev);iounmap (cp->regs);if (cp->wol_enabled)pci_set_power_state (pdev,PCI_D0 );
Quoted 7 lines · Pierre Ossman
Register interrupt handler when net device is registered. Avoids missing interrupts if the interrupt mask gets out of sync.
Signed-off-by Pierre Ossman <[email protected]>---
Quoted 9 lines
The reason this patch is needed for me is that the resume function is broken. It enables interrupts unconditionally, but the interrupt handler is only registered when the device is up.
I don't have enough knowledge about the driver to fix the resume function so this patch will instead make sure that the interrupt handler is registered at all times (which can be a nice safeguard even when the resume function gets fixed).
Any comments on this?