2.6.14-RC2 Bug? HiSpeed USB devices demoted to low-speed after resume
For both suspend-to-disk ("software suspend") and suspend-to-ram, the 2.6.14-RC2 kernel appears to disable ehci_hcd on resume.
That is, plugging in a hi-speed Mass Storage device *after* resume results in these syslog messages:
Quoted 2 lines
kernel: usb 3-1: new full speed USB device using
uhci_hcdand address 2
kernel: usb 3-1: not running at top speed; connect to a high speed hub
Very odd. The 2.6.13 kernel behaves much better, as does 2.6.14-RC2 *before* suspending:
Quoted 1 line
kernel: usb 5-5: new high speed USB device using
ehci_hcdand address 3
Unloading and reloading ehci_hcd restores high-speed USB operation, until the next suspend/resume.
WTF?