Skip to contentSkip to conversation

2.6.14-rt9 nanosleep() behavior..

DISCUSSION Gautam Thaker 1 participant 1 message Nov 11, 2005

lore
Share & tools
lore
#0 lore raw

I have noticed that nanosleep() on 2.6.14-rt9 built with real-time options listed at bottom of this page has unexpected behavior. In 2.6.13-RC4-RT53 if one called

nanosleep(20msec)

than actual sleep durations were very close to 20msec. (average number over 1 million samples yielded 20.008msec with minimum of 20.007msec and maximum of 20.060 msec).
(2.6.13-RC4-RT53 nanosleep(20msec) histogram can be viewed at:

http://www.atl.external.lmco.com/projects/QoS/compare/j_data/linux/2.6.13-RC4-RT-53-07/basement_prio_95_noload_with_chrt_on_pid_8_to_p97_20msec.out.png

with 2.6.14-rt9, nanosleep(20msec) returns average sleep interval of 21 msec.

Is the previously seen behavior in 2.6.13-RC4-RT-53-07 possible now under latest kernels?

New kernel (2.6.14-rt9) was built with:

Subarchitecture Type (PC-compatible) --->
Processor family (Pentium-Pro) --->
[*] Generic x86 support
[*] HPET Timer Support
[ ] Ktimers 64bit scalar representation
[*] High Resolution Timer Support
(1000) High Resolution Timer resolution (nanoseconds) [ ] Symmetric multi-processing support
Preemption Mode (Complete Preemption (Real-Time)) --->
--- Thread Softirqs
--- Thread Hardirqs
--- Preemptible RCU
[*] /proc stats for preemptible RCU read-side critical sections
[ ] /proc torture tests for RCU
[ ] Local APIC support on uniprocessors
[*] Machine Check Exception
< > Check for non-fatal errors on AMD Athlon/Duron / Intel Pentium
<M> Toshiba Laptop support
<M> Dell laptop support
[ ] Enable X86 board specific fixups for reboot <M> /dev/cpu/microcode - Intel IA32 CPU microcode support <M> /dev/cpu/*/msr - Model-specific register support <M> /dev/cpu/*/cpuid - CPU information support
Firmware Drivers --->
High Memory Support (4GB) --->
Memory model (Flat Memory) --->
[*] Allocate 3rd-level pagetables from highmem
[ ] Math emulation
[*] MTRR (Memory Type Range Register) support
[ ] Boot from EFI support (EXPERIMENTAL)
[*] Use register arguments (EXPERIMENTAL)
[*] Enable seccomp to safely compute untrusted bytecode
Timer frequency (1000 HZ) --->
[ ] kexec system call (EXPERIMENTAL)