Skip to contentSkip to conversation

REPOST: Problem kernel 2.6.14.3 / dual xeon w/HT / correction

DISCUSSION Trilight 1 participant 1 message Dec 16, 2005

lore
Share & tools
lore

Trilight

author
#0 lore raw

Hi all,

I have to correct my previous post;

Machine specs:

Dell Precision workstation 650 / latest dell bios A05 Dual Xeon 2.4 Ghz w/HT

Kernel: 2.6.14.3 (vanilla)

I noticed that the system after X reboots, this time 4, it boots up successfuly and i see no errors from ACPI during boot. This is without any boot parameters. Previously i used acpi=off noapic which increased the chance of a successful boot (not sure about this, didn't count that)

But during those automatic reboots this is the info i could capture (it did not get logged btw):

"
<cpu0 is detected and described>
...booting processor 1/2 EIP 2000....
inquiring remote apic #1
apic #1 ID failed
apic #1 VERSION failed
apic # SPIV failed
....not responding cpu #1
cannot use it
then the same happens when it goes to the next cpu, only then it says apic #6 (sometimes #7)
cannot use it
"

The weird thing is that now for example i booted up perfectly,no errors, no acpi weirdness...is this a kernel issue ? The previous o.s was linux Redhat ws Enterprise which never had these problems.

I'd greatly appreciate it if some one can give a helping hand or if i can supply more information. The DSDT table was looked at by an expert from Dell and he said this could not be the problem i was describing.