Belkin F8T009 USB dongle uses Broadcom
Hi
I have a Nokia HDW-3 and a Belkin F8T009 USB dongle.
This is mainly just a report that Belkin have reverted to using Broadcom chips
I guess I'm returning this one since I wanted to use SCO to get a voice connection to my headset. It actually connects perfectly and I can see the button presses coming back - just no sound. Searching the archives seems to indicate that Broadcom = no SCO = no sound (please yell if I'm wrong)
snd-bt-sco installed fine and I could run btsco and alsamixer picked up the Headset as hw1,0.
Oh, it was a bit misleading that I get the following during the ./btsco -v output:
...
i/o needed: connecting sco...
connected SCO channel
Done setting sco fd
...
it certainly implied that SCO was working.
My system is running kernel 2.6.14.5.
# hciconfig -a
hci0: Type: USB
BD Address: 00:0A:3A:68:47:68 ACL MTU: 377:10 SCO MTU: 16:0
UP RUNNING PSCAN ISCAN
RX bytes:17248 acl:517 sco:0 events:640 errors:0
TX bytes:9888 acl:499 sco:0 commands:59 errors:0
Features: 0xff 0xfe 0x0d 0x38 0x08 0x08 0x00 0x00
Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3
Link policy: RSWITCH HOLD SNIFF PARK
Link mode: SLAVE ACCEPT
Name: 'ash-0'
Class: 0x3e0100
Service Classes: Networking, Rendering, Capturing
Device Class: Computer, Uncategorized
HCI Ver: 1.2 (0x2) HCI Rev: 0x0 LMP Ver: 1.2 (0x2) LMP Subver: 0x309
Manufacturer: Broadcom Corporation (15)
# hciconfig hci0 revision
hci0: Type: USB
BD Address: 00:0A:3A:68:47:68 ACL MTU: 377:10 SCO MTU: 16:0
Firmware 0.3 / 9Marcel, cc'ed you in case you want to update the page on:
http://www.holtmann.org/linux/bluetooth/features.html
Also, by the way, you say on:
http://www.holtmann.org/linux/bluetooth/devices.html
"If the HCI Version field is filled in this table, then this device should also work perfect with Linux."
You may want to change that since clearly only CSR chipsets (IIRC) support SCO.
Also - thanks for all the work on BlueZ - I'm looking forward to getting another (CSR) dongle and getting it working.
David