Skip to contentSkip to conversation

sky2: fix hang on Yukon-EC (0xb6) rev 1

PATCH New Carl-Daniel Hailfinger 1 participant 1 message Jan 24, 2006

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 sky2: fix hang on Yukon-EC (0xb6) rev 1

This patch for sky2 fixes a hang on Yukon-EC (0xb6) rev 1 where suddenly no more interrupts were delivered.

I don't know the real cause of the hang due to lack of docs, but the patch has been running stable for a few hours whereas the unmodified driver will hang after less than 2 minutes.

Regards,
Carl-Daniel

Signature · 32 lines
http://www.hailfinger.org/

Signed-off-by: Carl-Daniel Hailfinger <[email protected]>

--- linux-2.6.15/drivers/net/sky2.c	2006-01-23 23:41:35.000000000 +0100
+++ linux-2.6.15/drivers/net/sky2.c	2006-01-24 14:12:12.000000000 +0100
@@ -1913,8 +1913,26 @@
 	}
 
 exit_loop:
+	/* Is this really a good idea?
+	 * We clear all IRQs although there may be pending work due to
+	 * - packets arrived since start of this function
+	 * - the (++work_done >= to_do) abort
+	 */
 	sky2_write32(hw, STAT_CTRL, SC_STAT_CLR_IRQ);
 
+	/* Pending resolution of the comment above, at least kick the
+	 * STAT_LEV_TIMER_CTRL timer.
+	 * This fixes my hangs on Yukon-EC (0xb6) rev 1.
+	 * The if clause is there to start the timer only if it has been
+	 * configured correctly and not been disabled via ethtool.
+	 * Maybe it would be sufficient to only restart the timer if
+	 * there is pending work. Without docs, that is hard to say.
+	 */
+	if (sky2_read8(hw, STAT_LEV_TIMER_CTRL) == TIM_START) {
+		sky2_write8(hw, STAT_LEV_TIMER_CTRL, TIM_STOP);
+		sky2_write8(hw, STAT_LEV_TIMER_CTRL, TIM_START);
+	}
+
 	sky2_tx_check(hw, 0, tx_done[0]);
 	sky2_tx_check(hw, 1, tx_done[1]);