lpfc 8.1.2 : Allow turning on internal loop-back mode

@@ -195,6 +195,9 @@ lpfc_init_link(struct lpfc_hba * phba,
 		mb->un.varInitLnk.link_flags = FLAGS_TOPOLOGY_MODE_PT_PT;
 		mb->un.varInitLnk.link_flags |= FLAGS_TOPOLOGY_FAILOVER;
 		break;
+	case FLAGS_LOCAL_LB:
+		mb->un.varInitLnk.link_flags = FLAGS_LOCAL_LB;
+		break;
 	}
 
 	/* NEW_FEATURE

@@ -616,6 +616,7 @@ LPFC_ATTR_RW(nodev_tmo, 30, 0, 255,
 /*
 # lpfc_topology:  link topology for init link
 #            0x0  = attempt loop mode then point-to-point
+#            0x01 = internal loopback mode
 #            0x02 = attempt point-to-point mode only
 #            0x04 = attempt loop mode only
 #            0x06 = attempt point-to-point mode then loop

@@ -623,7 +624,7 @@ LPFC_ATTR_RW(nodev_tmo, 30, 0, 255,
 # Set loop mode if you want to run as an NL_Port. Value range is [0,0x6].
 # Default value is 0.
 */
-LPFC_ATTR_R(topology, 0, 0, 6, "Select Fibre Channel topology");
+LPFC_ATTR_RW(topology, 0, 0, 6, "Select Fibre Channel topology");
 
 /*
 # lpfc_link_speed: Link speed selection for initializing the Fibre Channel