Skip to contentSkip to conversation

U-Boot in NAND Flash on a 440EP?

U-Boot-Users John Otken 2 participants 2 messages Feb 9, 2006

lore
Share & tools
lore

John Otken

author
#0 lore raw

Hi Wolfgang,

I'm researching U-Boot on an upcoming NAND-flash only 440EP board. I reviewed the archive, but I'd like to know your current thoughts on running U-Boot from NAND flash.

Tools could be a problem too. Embedded Toolsmith's Guardian does not support NAND and I don't think Abatron has it either.

Thanks, John

#1 lore raw
Quoted 4 lines · In message <[email protected]> you wrote:

I'm researching U-Boot on an upcoming NAND-flash only 440EP board. I reviewed the archive, but I'd like to know your current thoughts on running U-Boot from NAND flash.

IMHO it's not worth the effort (unless you sell *really* high [6 digits upward] volumes). But I'm just a software guy, and usually I can just ignore manufacturing cost because this is a SEP (somebody else's problem :-).

I recommend to have at least enough NOR flash on the board to fit U-Boot in it. 256 kB would be sufficient, but you probably will not find parts below 512 kB anyway.

Quoted 2 lines

Tools could be a problem too. Embedded Toolsmith's Guardian does not support NAND and I don't think Abatron has it either.

Indeed. But you will end up writing a primary bootstrap loader anyway, because you will not be able to run standard U-Boot directly from NAND.

Best regards,

Wolfgang Denk

Signature · 6 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"One day," said a dull voice from down below, "I'm going to  be  back
in  form again and you're going to be very sorry you said that. For a
very long time. I might even go so far as to make even more Time just
for you to be sorry in."              - Terry Pratchett, _Small Gods_