Skip to contentSkip to conversation

NCR 53c700-66 MCA(EISA) doesn't want to work(2.4.x)

DISCUSSION Zdenek Styblik 2 participants 2 messages Feb 11, 2006 – Feb 12, 2006

lore
Share & tools
lore
#0 lore raw

Hello,

I have Intel Professional Workstation with LP468 motherboard which has everything else except PCI. There is integrated SCSI controller NCR 53c700-66 50pin which is probably on MCA(or EISA bus). Problem is that I can't make it work. I tried NCR 53c7xx, 8xx support(naturally), but no way. I tried all other drivers, but no success. Googling around was also unsuccessful. Everything points on that it should work, but it does not.

# quote from Intel Professional Workstation documentation
1. NCR 53C700 SCSI I/O Processor (SIOP)
The on-board SCSI I/O processor is a NCR 53C700. This component has
internal FIFOs on the SCSI and host data
busses, 32-bit address and data busses, and an internal SCRIPTS
processor capable of fast DMA. A custom ASIC is
used to convert the 386-like bus interface of the NCR 53C700 to the
asynchronous strobed interface required by the
82359 DRAM Controller. The SIOP runs at 33 MHz, the maximum
theoretical data transfer rate is 66 MBytes/sec across
the Buffered Bus, and 8.25 MBytes/sec across the SCSI bus.
# end of quote

Do you have any ideas how to make this SCSI controller to work?

Thank you very much for your replies.

Zdenek Styblik

#1 lore raw
Quoted 4 lines · Zdenek Styblik

I have Intel Professional Workstation with LP468 motherboard which has everything else except PCI. There is integrated SCSI controller NCR 53c700-66 50pin which is probably on MCA(or EISA bus). Problem is that I can't make it work. I tried NCR 53c7xx, 8xx support(naturally), but

I had an old panther board years and years ago although it blew up in the end and which is similar. I always used the IDE on it.

There is an NCR53C700 core driver in the SCSI layer and MCA drivers for a couple of boards but at minimum I suspect you are looking at writing a new board interface assuming you can get enough information to do so.