Freescale 8272ADS configuration
Hi all,
I have a new Freescale 8272ADS board that I need to load uboot and linux on. I have read all the documentation that came with the board but unfortunately it doesn't explain how to bring up the board from scratch. Does anyone know what I need to do to load uboot and linux on this board ?
Thanks,
Carlos
Carlos,
You need to load u-boot using the following BDI2000 config file:
ftp://ftp.denx.de/pub/BDI2000/MPC8260ADS.cfg
u-boot itself needs to be configured with
make MPC8272ADS_config
before it is built.
The kernel needs to be configured with
make ads8272_config && make oldconfig
before it is built.
And most importantly you should read the user manual on
http://www.denx.de/wiki/DULG/Manual
It's a bit 8xx centric but most of it applies to the 82xx as well.
Alex
Quoted 16 lines · On Wed, 12 Apr 2006 18:22:33 -0700 Carlos Munoz <[email protected]> wrote:
Hi all,
I have a new Freescale 8272ADS board that I need to load uboot and linux on. I have read all the documentation that came with the board but unfortunately it doesn't explain how to bring up the board from scratch. Does anyone know what I need to do to load uboot and linux on this board ?
Thanks,
Carlos
_______________________________________________
Linuxppc-embedded mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-embedded
Quoted 6 lines · In message <[email protected]> you wrote:
And most importantly you should read the user manual on
http://www.denx.de/wiki/DULG/Manual
It's a bit 8xx centric but most of it applies to the 82xx as well.
There are also versions for other processors, like MPC5200, MPC834x, MPC85xx, PPC405 and PPC440; see
http://www.denx.de/wiki/DULG/BoardSelect
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] Any sufficiently advanced bug is indistinguishable from a feature. - Rich Kulawiec