Skip to contentSkip to conversation

libata1.patch

DISCUSSION Phil Dibowitz 1 participant 1 message Apr 23, 2006 libata

lore
Share & tools
lore
#0 lore raw

Jeff / et al,

My general email to the list still didn't get a response, I figured I'd try a different subject line and CC'ing Jeff directly.

I tried 2.6.15.6-libata1.patch and was able to succesfully use a PATA drive from my Promise 20378 card! Thanks for the hard work. It works great for the most part.

One big question/problem I had:

The kernel raid autodetection doesn't work here. Though I'm not clear if it supports going across controllers. I set up a raid-1 array wtih a drive on my other controller, set the partition type to autodetect, but a reboot left my array with just the drive not on the promise card. Should this work? Am I missing something?

Also - is there an effort to get this merged into mainline?

Note that my box has a 82801EB/ER controller which is currently my primarycontoller as well as the Promise PDC20378 which is what I'm using this patch for.

As a side note: Currently my BIOS's ATA settings are "SATA mode" - I also have "PATA mode" "SATA+PATA mode". I tried SATA+PATA and I get a bunch of IRQ16 ignored messages, a few tracebacks, and a LOT of slowness. I also get 3 scsi controller devices. I haven't tried the PATA mode.

Thanks.

Signature · 7 lines
Phil Dibowitz                             [email protected]
Freeware and Technical Pages              Insanity Palace of Metallica
http://www.phildev.net/                   http://www.ipom.com/

"Be who you are and say what you feel, because those who mind don't
matter and those who matter don't mind."
 - Dr. Suess