scsi hd
I am trying to install an scsi hd (IBM DDRS 34560) on a P4 runnning Slackware 10.2 / 2.6.13. The hd came out of a pII/300 I found and which worked perfectly once I changed the ram. At the moment it has an ntfs system on it.
The scsi adaptor it was attached to is an Adaptec AHA-2940U/UW/D / AIC-7881U. I think the right module is the aha152x.
CONFIG_SCSI = y
I don't know what else I need configured.
The aha152x module loads without errors. Where do I go from here? /proc/scsi/scsi does not list any devices. Presumably I am missing one or more steps.
TIA,
Andrew
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs
Quoted 6 lines · Hal MacArgle
I've seen no replies on the list so:
Have you tried modprobe aic7xxx??
You, sir, are a genius. I thank you.
Andrew
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs