Skip to contentSkip to conversation

SCSI device not spinning up on rw

DISCUSSION Ruben Faelens 1 participant 1 message Jun 3, 2006

lore
Share & tools
lore
#0 lore raw

I have a SCSI disk, which I want to spin down when the system is not in use. I do this by using sdparm, scsi-spin or sg-utils. These tools all spin down the SCSI drive by using an IOCTL.

Problem is that the kernel doesn't spin the drive back up. When a process requests data from the disk (a simple ls), the kernel responds with an I/O error. After some of these errors, reiserfs marks the drive read-only.

This bug is also described here:
http://bugzilla.kernel.org/show_bug.cgi?id=6627

This bug was solved by scsi-idle (http://lost-habit.com/scsi.html) in 2.4 kernels, but the patch hasn't been ported to 2.6. It's also a dirty hack, by someone who knows little of the internals of the SCSI system.

I read the LKML-archives, and they turned up some old posts in 09-2005 about this subject, where somebody says implementing this in SCSI could get messy.

However, it seems to me that all it takes is a call to sd_spinup_disk() in sd.c. When I add this in sd_init_command, the kernel crashes when confronted with a SCSI disk. Then again, I'm no kernel hacker, this is the first time I even read the source...

Could someone more experienced than me look into this? IMHO this should be doable, because the spinup-on-read/write has been implemented in SATA and IDE I/O subsystems. Then again, I read SATA and IDE disks handle this for themselves.

So if someone would enlighten me, that would be great!

As a side note: maybe it's my disk that's having these problems? It's an old SCSI disk in a HP 712/80 from 1994. Manual spinup does work however...

Ruben Faelens
BELGIUM