Skip to contentSkip to conversation

usb error? linux 2.6.15-1.1831_FC4

DISCUSSION Stephen Clark 2 participants 2 messages Jun 7, 2006 – Jun 8, 2006

lore
Share & tools
lore
#0 lore raw

Hello List,

Anyone have an idea how I could fix this - I plugged in an ActionTec dualpc modem configured so it would ask for a new flash. Where do I put the cxacru-fw.bin file?

Jun  3 17:43:16 joker kernel: usb 1-2: new full speed USB device using uhci_hcd
and address 65
Jun  3 17:43:16 joker kernel: NET: Registered protocol family 8
Jun  3 17:43:16 joker kernel: NET: Registered protocol family 20
Jun  3 17:43:18 joker kernel: usbcore: registered new driver cxacru
Jun  3 17:43:19 joker kernel: cxacru 1-2:1.0: firmware (cxacru-fw.bin) unavailab

le (hotplug misconfiguration?)

Thanks,
Steve

Signature · 3 lines
"They that give up essential liberty to obtain temporary safety, deserve neither liberty nor safety."  (Ben Franklin)

"The course of history shows that as a government grows, liberty decreases."  (Thomas Jefferson)
#1 lore raw
Quoted 4 lines

Anyone have an idea how I could fix this - I plugged in an ActionTec dualpc modem
configured so it would ask for a new flash. Where do I put the cxacru-fw.bin file?

The usual place nowadays seems to be in /lib/firmware/ Depends on your distribution though. If you are using hotplug rather than udev, you can find a list of firmware directories in hotplug's firmware script.

Quoted 9 lines
Jun  3 17:43:16 joker kernel: usb 1-2: new full speed USB device using 
uhci_hcd
and address 65
Jun  3 17:43:16 joker kernel: NET: Registered protocol family 8
Jun  3 17:43:16 joker kernel: NET: Registered protocol family 20
Jun  3 17:43:18 joker kernel: usbcore: registered new driver cxacru
Jun  3 17:43:19 joker kernel: cxacru 1-2:1.0: firmware (cxacru-fw.bin) 

unavailab
le (hotplug misconfiguration?)

If the cxacru module is being loaded from an initrd, then it may not be able to find the firmware if the root filesystem hasn't been mounted yet. In that case the simplest thing is probably to place the firmware appropriately in the initrd.

Ciao,

Duncan.