Skip to contentSkip to conversation

Question about uboot environment variables and setting uboot in the parallel flash

U-Boot-Users Wolfgang Denk 1 participant 1 message Jun 12, 2006 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

Hello,

Quoted 2 lines · in message <[email protected]> you wrote:

I wander, if I could ask you a question Wolfgang.

Of course you can. You just did.

Quoted 7 lines

I am trying to load uboot 1.1.4 directly into a parallel flash on a board similar to 91rm9200ek. I have written a driver, and the loading to flash occurs perfect without errors.
However, I have a problem, after the board resets. Once uboot 1.1.4 loads, it crashes. I believe that the Environment variables are being saved and overwritten by uboot. I am experiemnting with settings, but I don't know the solution yet.

U-Boot does not automatically write to flash memory, only on behalf of user commands.

Quoted 5 lines

Here is what I do:

Load uboot into ram
Execute uboot from ram
Load uboot into flash

This is a different image of U-Boot, one configured correctly (i. e. for booting from flash)? Otherwise see the FAQ:
http://www.denx.de/wiki/view/DULG/CanUBootBeConfiguredSuchThatItCanBeStartedInRAM

Quoted 2 lines

Reboot
Uboot loads to prompt and crashes

Well, debug the code. Obviously your port / configuration is broken.

Quoted 1 line

Sorry to bug, but I don't have anywhere else to go,

Well, you *also* posted on the mailing list.

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Syntactic sugar causes cancer of the semicolon.
                - Epigrams in Programming, ACM SIGPLAN Sept. 1982