Skip to contentSkip to conversation

Linux ppc port problem

DISCUSSION robinpv 2 participants 2 messages Jun 21, 2006

lore
Share & tools
lore

robinpv

author
#0 lore raw

Hi ,
I am trying to the port linux to the mpc5200 based board( Lite5200.) I am using linux version 2.6.16.1. I am getting the below message
after that, linux seems to he in hanged state
I debugged and found that the control is reaching the schedule() in
rest_init() which is the last function called in start_kernel().
I have set the command line arguements to "console=ttyPSC0,115200
root=/dev/ram0 rw ramdisk_size=16384"
Can you suggest, how to proceed or what could be the problem.

With regards
Robin

## Booting image at ff000000 ...

  Image Name:   Linux-2.6.16.1
  Image Type:   PowerPC Linux Kernel Image (gzip compressed)
  Data Size:    1301999 Bytes =  1.2 MB

Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
## Loading RAMDisk Image at ff200000 ...

  Image Name:   ramdisk
  Image Type:   PowerPC Linux RAMDisk Image (gzip compressed)
  Data Size:    2788700 Bytes =  2.7 MB

Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Loading Ramdisk to 03d05000, end 03fadd5c ... OK
id mach(): done
MMU:enter
MMU:hw init
MMU:mapin
MMU:setio
MMU:exit
setup_arch: enter
setup_arch: bootmem
arch: exit

#1 lore raw
Quoted 2 lines · In message <[email protected]> you wrote:

I am trying to the port linux to the mpc5200 based board( Lite5200.)

Why are you doing this? Why don't you use the existing code for this board?

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected]
I mean, I . . . think to understand you, I just don't know  what  you
are saying ...                        - Terry Pratchett, _Soul Music_