Skip to contentSkip to conversation

Setting strataflash lock bit accidentally

U-Boot-Users llandre 2 participants 4 messages Jul 21, 2006

lore
Share & tools
lore

llandre

author
#0 lore raw

Let's assume that, because a software bug, an application has accidentally set the lock bit of the flash sector used to store the U-Boot environment. In this case, when trying to store a new environment with the saveenv command, U-Boot would not be able to complete the operation. Is it enough to define CFG_FLASH_PROTECTION in order to handle this situation and to allow U-Boot to unlock the sector (same thing would happen in case the locked sectors fall in the memrory area devoted to store kernels or ramsisks)? If no, how do you suggest to manage this situation?

TIA,
llandre

DAVE Electronics System House - R&D Department

web:   http://www.dave-tech.it
email: r&d2 at dave-tech.it
#1 lore raw
Quoted 9 lines · In message <[email protected]> you wrote:

Let's assume that, because a software bug, an application has accidentally set the lock bit of the flash sector used to store the U-Boot environment. In this case, when trying to store a new environment with the saveenv command, U-Boot would not be able to complete the operation. Is it enough to define CFG_FLASH_PROTECTION in order to handle this situation and to allow U-Boot to unlock the sector (same thing would happen in case the locked sectors fall in the memrory area devoted to store kernels or ramsisks)? If no, how do you suggest to manage this situation?

Use MTD tools under Linux to unlock the flash?

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
All a hacker needs is a tight PUSHJ, a loose pair of UUOs, and a warm
place to shift.
author
#2 lore raw
Quoted 11 lines
Quoted 9 lines

Let's assume that, because a software bug, an application has accidentally set the lock bit of the flash sector used to store the U-Boot environment. In this case, when trying to store a new environment with the saveenv command, U-Boot would not be able to complete the operation. Is it enough to define CFG_FLASH_PROTECTION in order to handle this situation and to allow U-Boot to unlock the sector (same thing would happen in case the locked sectors fall in the memrory area devoted to store kernels or ramsisks)? If no, how do you suggest to manage this situation?

Use MTD tools under Linux to unlock the flash?

Indeed this is a possible solution but I'm looking for a general one implemented in u-boot. In fact it must work with any operating system and I must assume o.s. might not provide MTD or similar tools.

Signature · 5 lines
llandre

DAVE Electronics System House - R&D Department
web:   http://www.dave-tech.it
email: r&d2 at dave-tech.it
#3 lore raw
Quoted 6 lines · In message <[email protected]> you wrote:
Quoted 2 lines

Use MTD tools under Linux to unlock the flash?

Indeed this is a possible solution but I'm looking for a general one implemented in u-boot. In fact it must work with any operating system and I must assume o.s. might not provide MTD or similar tools.

It is easy to postulate requirements. But seriously, if you are careless enough to use flash chips which can change modes or even lose data by just writing random data to sequential addresses then you must also accept the consequences. Either provide adequate recovery mechanisms in Linux or your OS of choice or in U-Boot.

I have to admit that I fail to understand what exactly your problem
is: if you want to use the hardware protection features in U-Boot (including the unlocking of locked sectors) then just enable this feature in U-Boot.

Best regards,

Wolfgang Denk

Signature · 3 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Nobody goes to that restaurant anymore. It's too crowded.