Firewire camera and PCMCIA card under Debian
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hello,
I am trying to connect a unibrain firewire camera to my T40 thinkpad using a PCMCIA firecard. I am running debian testing and kernel 2.6.15.
The card is detected and the output of dmeg follows but the camera doesn't even turn on and nothing happens when I connect it to the card! Any help would be greatly appreciated. Cheers,
Ali
Quoted 6 lines
ieee1394: raw1394:
/dev/raw1394device initialized
video1394: Installed video1394 module
usb 2-2: new full speed USB device usinguhci_hcdand address 3
pccard: card ejected from slot 1
ieee1394: Node removed: ID:BUS[0-00:1023] GUID[0814435800000528]
ohci1394: fw-host0: Set PHY Reg timeout [0xffffffff/0x00004000/100]
Quoted 9 lines
ohci1394: fw-host0: Set PHY Reg timeout [0xffffffff/0x00004000/100]
pccard: CardBus card inserted into slot 1
PCI: Enabling device 0000:07:00.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:07:00.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:07:00.0 to 64
ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[11] MMIO=[c4004000-c40047ff] Max Packet=[2048]
eth1394: eth1: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)
ieee1394: Host added: ID:BUS[0-00:1023] GUID[0814435800000528]
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs