LVM Missing Space
Hello,
I have been trying to setup LVM for the first time on an RAID 5 Array. The problem I have is that the raid array has 640Gb of usable space, but when I create the LVM Physical Volume and Volume group I wind up with 596Gb. I don't know where 44 gigs went to. I am on Debian with a 2.6.17 kernel.
When I do fdisk -l I get this:
fdisk -l
Disk /dev/sda: 639.9 GB, 639977390080 bytes
255 heads, 63 sectors/track, 77806 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk /dev/sda doesn't contain a valid partition table
Disk /dev/hda: 163.9 GB, 163928604672 bytes
255 heads, 63 sectors/track, 19929 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System /dev/hda1 * 1 19740 158561518+ 83 Linux /dev/hda2 19741 19929 1518142+ 5 Extended /dev/hda5 19741 19929 1518111 82 Linux swap / Solaris
Here you can see /dev/sda is 639.9GB.
I then do:
$ pvcreate /dev/sda Physical volume "/dev/sda" successfully created $ pvdisplay /dev/sda --- NEW Physical volume --- PV Name /dev/sda VG Name PV Size 596.03 GB Allocatable NO PE Size (KByte) 0 Total PE 0 Free PE 0 Allocated PE 0 PV UUID po9rKd-gOKR-jfmx-yjUm-R5Wl-us2j-s6qZN1
You see here I only get 596Gb. Also if I run the lvmdiskscan utility I get:
lvmdiskscan
/dev/ram0 [ 8.00 MB] /dev/sda [ 596.03 GB] LVM physical volume /dev/ram1 [ 8.00 MB] /dev/hda1 [ 151.22 GB] /dev/ram2 [ 8.00 MB] /dev/ram3 [ 8.00 MB] /dev/ram4 [ 8.00 MB] /dev/ram5 [ 8.00 MB] /dev/hda5 [ 1.45 GB] /dev/ram6 [ 8.00 MB] /dev/ram7 [ 8.00 MB] /dev/ram8 [ 8.00 MB] /dev/ram9 [ 8.00 MB] /dev/ram10 [ 8.00 MB] /dev/ram11 [ 8.00 MB] /dev/ram12 [ 8.00 MB] /dev/ram13 [ 8.00 MB] /dev/ram14 [ 8.00 MB] /dev/ram15 [ 8.00 MB]
0 disks
18 partitions
1 LVM physical volume whole disk
0 LVM physical volumes
Again listing 596.03Gb. What's going on here. Why do I seem to be getting less capacity in the physical volume than actually on the drive. I really would like to use LVM but if I am going to lose 40Gigs then its not really worth it. Any help or ideas would be appreciated.
Regards,
Michael MacFadden
Michael,
You're being misled -- fdisk says 639977390080 bytes ... divide that by 1024 / 1024 / 1024 *IS* 596Gb.
Problem is the difference between Gb and Gb ... ;) Some people just divide by 1 billion to get Gb, but ... others divide by 2^30, (1024 * 1024 * 1024) to get Gb.
LVM uses 2^30 to equal 1Gb,
Fdisk uses 10^9 to equal 1Gb.
-- Mitch
Quoted 88 lines · Michael MacFadden
Hello,
I have been trying to setup LVM for the first time on an RAID 5 Array. The problem I have is that the raid array has 640Gb of usable space, but when I create the LVM Physical Volume and Volume group I wind up with 596Gb. I don't know where 44 gigs went to. I am on Debian with a 2.6.17 kernel.
When I do fdisk -l I get this:
fdisk -l
Disk
/dev/sda: 639.9 GB, 639977390080 bytes
255 heads, 63 sectors/track, 77806 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytesDisk
/dev/sdadoesn't contain a valid partition tableDisk
/dev/hda: 163.9 GB, 163928604672 bytes
255 heads, 63 sectors/track, 19929 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytesDevice Boot Start End Blocks Id System /dev/hda1 * 1 19740 158561518+ 83 Linux /dev/hda2 19741 19929 1518142+ 5 Extended /dev/hda5 19741 19929 1518111 82 Linux swap / SolarisHere you can see
/dev/sdais 639.9GB.I then do:
$ pvcreate /dev/sda Physical volume "/dev/sda" successfully created $ pvdisplay /dev/sda --- NEW Physical volume --- PV Name /dev/sda VG Name PV Size 596.03 GB Allocatable NO PE Size (KByte) 0 Total PE 0 Free PE 0 Allocated PE 0 PV UUID po9rKd-gOKR-jfmx-yjUm-R5Wl-us2j-s6qZN1You see here I only get 596Gb. Also if I run the lvmdiskscan utility I get:
lvmdiskscan
/dev/ram0 [ 8.00 MB] /dev/sda [ 596.03 GB] LVM physical volume /dev/ram1 [ 8.00 MB] /dev/hda1 [ 151.22 GB] /dev/ram2 [ 8.00 MB] /dev/ram3 [ 8.00 MB] /dev/ram4 [ 8.00 MB] /dev/ram5 [ 8.00 MB] /dev/hda5 [ 1.45 GB] /dev/ram6 [ 8.00 MB] /dev/ram7 [ 8.00 MB] /dev/ram8 [ 8.00 MB] /dev/ram9 [ 8.00 MB] /dev/ram10 [ 8.00 MB] /dev/ram11 [ 8.00 MB] /dev/ram12 [ 8.00 MB] /dev/ram13 [ 8.00 MB] /dev/ram14 [ 8.00 MB] /dev/ram15 [ 8.00 MB]0 disks
18 partitions
1 LVM physical volume whole disk
0 LVM physical volumesAgain listing 596.03Gb. What's going on here. Why do I seem to be getting less capacity in the physical volume than actually on the drive. I really would like to use LVM but if I am going to lose 40Gigs then its not really worth it. Any help or ideas would be appreciated.
Regards,
Michael MacFadden_______________________________________________
linux-lvm mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/linux-lvm
read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/