dev IFB, few questions
I've made some tests...
eth2 is my internal interface, LAN is connected here.
Before I had IMQ device in AB mode...
PREROUTING [A]fter NAT, POSTROUTING [B]efore NAT.
I want the same situation on ifb.
I do this in this way:
---
# incoming traffic here from LAN is before NAT tc qdisc add dev eth2 handle ffff: ingress
# outcoming traffic here from WAN is after NAT tc qdisc add dev eth2 root handle 1:0 htb
tc filter add dev eth2 parent ffff: protocol ip prio 1 u32 match ip src 192.168.0.0/24 flowid 1:1 action mirred egress mirror dev ifb0
tc filter add dev eth2 parent 1:0 protocol ip prio 1 u32 match ip dst 192.168.0.0/24 flowid 1:2 action mirred egress mirror dev ifb0
---
Everything is working fine. I can catch packets from and to users by they ip address. Of course in my script I'll use act_mirred redirect, but now I'm testing on mirror.
But my question is... Am I doing this in right way? Anybody knows better rules?
And another question, Is any possible to recognize if traffic is incoming or outcoming from device using u32?
I'm doing this - ip src 192.168.0.0/24 or ip dst - but to do this I need to know IP addresses of my LAN. Is it possible to do this without this knowledge? Recognize incoming and outcoming traffic on device by filters (u32)...
Thanks in advance :)
Konrad Cempura
(a.k.a. Lenthir)
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc