OMAP1 realtime patch 2.6.21-rc3-rt0-omap1

Index: linux-osk/arch/arm/mach-omap1/time.c
===================================================================
@@ -42,6 +42,7 @@
 #include <linux/clk.h>
 #include <linux/err.h>
 #include <linux/clocksource.h>
+#include <linux/clockchips.h>
 
 #include <asm/system.h>
 #include <asm/hardware.h>

@@ -102,15 +103,33 @@ static inline unsigned long omap_mpu_tim
 	return timer->read_tim;
 }
 
-static inline void omap_mpu_timer_start(int nr, unsigned long load_val)
+static inline void omap_mpu_set_autoreset(int nr)
 {
 	volatile omap_mpu_timer_regs_t* timer = omap_mpu_timer_base(nr);
 
+	timer->cntl = timer->cntl | MPU_TIMER_AR;
+}
+
+static inline void omap_mpu_remove_autoreset(int nr)
+{
+	volatile omap_mpu_timer_regs_t* timer = omap_mpu_timer_base(nr);
+
+	timer->cntl = timer->cntl & ~MPU_TIMER_AR;
+}
+
+static inline void omap_mpu_timer_start(int nr, unsigned long load_val,
+					int autoreset)
+{
+	volatile omap_mpu_timer_regs_t* timer = omap_mpu_timer_base(nr);
+	unsigned int timerflags = (MPU_TIMER_CLOCK_ENABLE | MPU_TIMER_ST);
+
+	if (autoreset) timerflags |= MPU_TIMER_AR;
+
 	timer->cntl = MPU_TIMER_CLOCK_ENABLE;
 	udelay(1);
 	timer->load_tim = load_val;
         udelay(1);
-	timer->cntl = (MPU_TIMER_CLOCK_ENABLE | MPU_TIMER_AR | MPU_TIMER_ST);
+	timer->cntl = timerflags;
 }
 
 /*

@@ -118,12 +137,42 @@ static inline void omap_mpu_timer_start(
  * MPU timer 1 ... count down to zero, interrupt, reload
  * ---------------------------------------------------------------------------
  */
+static int omap_mpu_set_next_event(unsigned long cycles,
+				    struct clock_event_device *evt)
+{
+	omap_mpu_timer_start(0, cycles, 0);
+	return 0;
+}
+
+static void omap_mpu_set_mode(enum clock_event_mode mode,
+			      struct clock_event_device *evt)
+{
+	switch (mode) {
+	case CLOCK_EVT_MODE_PERIODIC:
+		omap_mpu_set_autoreset(0);
+		break;
+	case CLOCK_EVT_MODE_ONESHOT:
+		omap_mpu_remove_autoreset(0);
+		break;
+	case CLOCK_EVT_MODE_UNUSED:
+	case CLOCK_EVT_MODE_SHUTDOWN:
+		break;
+	}
+}
+
+static struct clock_event_device clockevent_mpu_timer1 = {
+	.name		= "mpu_timer1",
+	.features	= CLOCK_EVT_FEAT_PERIODIC, CLOCK_EVT_FEAT_ONESHOT,
+	.shift		= 32,
+	.set_next_event	= omap_mpu_set_next_event,
+	.set_mode	= omap_mpu_set_mode,
+};
+
 static irqreturn_t omap_mpu_timer1_interrupt(int irq, void *dev_id)
 {
-	write_seqlock(&xtime_lock);
-	/* NOTE:  no lost-tick detection/handling! */
-	timer_tick();
-	write_sequnlock(&xtime_lock);
+	struct clock_event_device *evt = &clockevent_mpu_timer1;
+
+	evt->event_handler(evt);
 
 	return IRQ_HANDLED;
 }

@@ -139,7 +188,17 @@ static __init void omap_init_mpu_timer(u
 	set_cyc2ns_scale(rate / 1000);
 
 	setup_irq(INT_TIMER1, &omap_mpu_timer1_irq);
-	omap_mpu_timer_start(0, (rate / HZ) - 1);
+	omap_mpu_timer_start(0, (rate / HZ) - 1, 1);
+
+	clockevent_mpu_timer1.mult = div_sc(rate, NSEC_PER_SEC,
+					    clockevent_mpu_timer1.shift);
+	clockevent_mpu_timer1.max_delta_ns =
+		clockevent_delta2ns(-1, &clockevent_mpu_timer1);
+	clockevent_mpu_timer1.min_delta_ns =
+		clockevent_delta2ns(1, &clockevent_mpu_timer1);
+
+	clockevent_mpu_timer1.cpumask = cpumask_of_cpu(0);
+	clockevents_register_device(&clockevent_mpu_timer1);
 }
 
 /*

@@ -185,7 +244,7 @@ static void __init omap_init_clocksource
 		= clocksource_khz2mult(rate/1000, clocksource_mpu.shift);
 
 	setup_irq(INT_TIMER2, &omap_mpu_timer2_irq);
-	omap_mpu_timer_start(1, ~0);
+	omap_mpu_timer_start(1, ~0, 1);
 
 	if (clocksource_register(&clocksource_mpu))
 		printk(err, clocksource_mpu.name);

127 lines not on this page · raw message

Index: linux-osk/kernel/irq/manage.c
===================================================================
@@ -628,6 +628,7 @@ static void thread_simple_irq(irq_desc_t
 	unsigned int irq = desc - irq_desc;
 	irqreturn_t action_ret;
 
+	restart:
 	if (action && !desc->depth) {
 		spin_unlock(&desc->lock);
 		action_ret = handle_IRQ_event(irq, action);

@@ -636,6 +637,19 @@ static void thread_simple_irq(irq_desc_t
 		if (!noirqdebug)
 			note_interrupt(irq, desc, action_ret);
 	}
+
+	/*
+	 * Some boards will disable an interrupt when it
+	 * sets IRQ_PENDING . So we have to remove the flag
+	 * and re-enable to handle it.
+	 */
+	if (desc->status & IRQ_PENDING) {
+		desc->status &= ~IRQ_PENDING;
+		if (desc->chip)
+			desc->chip->enable(irq);
+		goto restart;
+	}
+
 	desc->status &= ~IRQ_INPROGRESS;
 }
 

Index: linux-osk/sound/arm/omap/omap-alsa.c
===================================================================
@@ -168,7 +168,6 @@ static void audio_stop_dma(struct audio_
 	unsigned long flags;
 	ADEBUG();
 
-	spin_lock_irqsave(&s->dma_lock, flags);
 	s->active = 0;
 	s->period = 0;
 	s->periods = 0;

@@ -177,8 +176,6 @@ static void audio_stop_dma(struct audio_
 	omap_stop_alsa_sound_dma(s);
 
 	omap_clear_alsa_sound_dma(s);
-
-	spin_unlock_irqrestore(&s->dma_lock, flags);
 }
 
 /*

Index: linux-osk/arch/arm/plat-omap/gpio.c
===================================================================
@@ -136,7 +136,7 @@ struct gpio_bank {
 	u32 saved_fallingdetect;
 	u32 saved_risingdetect;
 #endif
-	spinlock_t lock;
+	raw_spinlock_t lock;
 };
 
 #define METHOD_MPUIO		0