TC Filter matching all
Hello!
I was always using "default" in HTB to choose default class, but now I
need to do it with filters. Tried following command:
# tc filter add dev eth0 protocol ip parent 10: prio 2 flowid 10:2 Unknown filter "flowid", hence option "10:2" is unparsable
It is from example in LARTC Howto.
My question is then - how to make a filter matching all without eating too much CPU cycles?
Thanks
Signature · 6 lines
Micha³ Margula, [email protected], http://alchemyx.uznam.net.pl/ "W ¿yciu piêkne s± tylko chwile" [Ryszard Riedel] _______________________________________________ LARTC mailing list [email protected] http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
I use this one for "match anything"
http://mailman.ds9a.nl/pipermail/lartc/2005q3/016774.html
Andreas
Quoting Michał Margula <[email protected]>:
Quoted 8 lines
Hello!
I was always using "default" in HTB to choose default class, but now I
need to do it with filters. Tried following command:# tc filter add dev eth0 protocol ip parent 10: prio 2 flowid 10:2 Unknown filter "flowid", hence option "10:2" is unparsable
Quoted 14 lines
It is from example in LARTC Howto.
My question is then - how to make a filter matching all without eating too much CPU cycles?
Thanks
Signature · 6 lines
Michał Margula, [email protected], http://alchemyx.uznam.net.pl/ "W życiu piękne są tylko chwile" [Ryszard Riedel] _______________________________________________ LARTC mailing list [email protected] http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc