MMC fixes for OMAP730.
Subsystems (2)
PATCH 8/12 MMC fixes for OMAP730.
This patch fixes the MMC register definitions for OMAP730. It also fixes an incorrect error reporting from the controller when sending the SD_SEND_RELATIVE_ADDR command during SD card initialization.
---drivers/mmc/host/omap.c | 56 +++++++++++++++++++++++++++++++++++++++++------
1 files changed, 49 insertions(+), 7 deletions(-)
drivers/mmc/host/omap.c +0 -0
@@ -39,6 +39,33 @@
#include <asm/arch/tps65010.h>
#include <asm/arch/board-sx1.h>
+#ifdef CONFIG_ARCH_OMAP730
+#define OMAP_MMC_REG_CMD 0x00 +#define OMAP_MMC_REG_ARGL 0x02 +#define OMAP_MMC_REG_ARGH 0x04 +#define OMAP_MMC_REG_CON 0x06 +#define OMAP_MMC_REG_STAT 0x08 +#define OMAP_MMC_REG_IE 0x0a +#define OMAP_MMC_REG_CTO 0x0c +#define OMAP_MMC_REG_DTO 0x0e +#define OMAP_MMC_REG_DATA 0x10 +#define OMAP_MMC_REG_BLEN 0x12 +#define OMAP_MMC_REG_NBLK 0x14 +#define OMAP_MMC_REG_BUF 0x16 +#define OMAP_MMC_REG_SDIO 0x1a +#define OMAP_MMC_REG_REV 0x1e +#define OMAP_MMC_REG_RSP0 0x20 +#define OMAP_MMC_REG_RSP1 0x22 +#define OMAP_MMC_REG_RSP2 0x24 +#define OMAP_MMC_REG_RSP3 0x26 +#define OMAP_MMC_REG_RSP4 0x28 +#define OMAP_MMC_REG_RSP5 0x2a +#define OMAP_MMC_REG_RSP6 0x2c +#define OMAP_MMC_REG_RSP7 0x2e +#define OMAP_MMC_REG_IOSR 0x30 +#define OMAP_MMC_REG_SYSC 0x32 +#define OMAP_MMC_REG_SYSS 0x34 +#else #define OMAP_MMC_REG_CMD 0x00 #define OMAP_MMC_REG_ARGL 0x04 #define OMAP_MMC_REG_ARGH 0x08 @@ -64,6 +91,7 @@ #define OMAP_MMC_REG_IOSR 0x60 #define OMAP_MMC_REG_SYSC 0x64 #define OMAP_MMC_REG_SYSS 0x68
+#endif
#define OMAP_MMC_STAT_CARD_ERR (1 << 14)
#define OMAP_MMC_STAT_CARD_IRQ (1 << 13)
@@ -524,19 +552,33 @@ static irqreturn_t mmc_omap_irq(int irq, void *dev_id)
}
if (status & OMAP_MMC_STAT_CARD_ERR) {- if (host->cmd && host->cmd->opcode == MMC_STOP_TRANSMISSION) {
+ if (host->cmd) {
u32 response = OMAP_MMC_READ(host, RSP6)
| (OMAP_MMC_READ(host, RSP7) << 16);
+
+ switch (host->cmd->opcode) {
/* STOP sometimes sets must-ignore bits */- if (!(response & (R1_CC_ERROR
- | R1_ILLEGAL_COMMAND
- | R1_COM_CRC_ERROR))) {
- end_command = 1;
- continue;
+ case MMC_STOP_TRANSMISSION:
+ if (!(response & (R1_CC_ERROR |
+ R1_ILLEGAL_COMMAND |
+ R1_COM_CRC_ERROR))) {
+ end_command = 1;
+ continue;
+ }
+ break;
+ case MMC_SET_RELATIVE_ADDR:
+ if (!(response & (R1_WP_ERASE_SKIP |
+ R1_CARD_ECC_DISABLED |
+ R1_ERASE_RESET))) {
+ end_command = 1;
+ continue;
+ }
+ break;
}
}- dev_dbg(mmc_dev(host->mmc), "card status error (CMD%d)\n",
+ dev_dbg(mmc_dev(host->mmc),
+ "card status error (CMD%d)\n",
host->cmd->opcode);
if (host->cmd) {
host->cmd->error = MMC_ERR_FAILED;Signature · 1 line
1.5.1.3