scsi disk help file is not complete
Good day,
When doing make menuconfig one comes across CONFIG_BLK_DEV_SD. The help file states that this is for scsi disks.NO MENTION IS MADE THAT IT IS NEEDE FOR SATA DISKS AS WELL!
Would have saved me a lot of time if the help was up to date. I hope this can be changed so others can make a kernel for sata systems quicker.
Thanks,
Gerard
PATCH 1/1 scsi disk help file is not complete
Quoted 7 lines · On Mon, 11 Jun 2007 20:28:16 +0200 api wrote:
Good day,
When doing make menuconfig one comes acrossCONFIG_BLK_DEV_SD. The help file states that this is for scsi disks.NO MENTION IS MADE THAT IT IS NEEDE FOR SATA DISKS AS WELL!
Would have saved me a lot of time if the help was up to date. I hope this can be changed so others can make a kernel for sata systems quicker.
From: Randy Dunlap <[email protected]>
Add help info for BLK_DEV_SD referring to its use in SATA or PATA driver configurations.
Add help text for "ATA" indicating that it probably needs some SCSI config symbols enabled in order to be useful.
--- drivers/ata/Kconfig | 5 +++++ drivers/scsi/Kconfig | 1 + 2 files changed, 6 insertions(+)
drivers/scsi/Kconfig +1 -0
@@ -60,6 +60,7 @@ config BLK_DEV_SD depends on SCSI ---help--- If you want to use SCSI hard disks, Fibre Channel disks, + Serial ATA (SATA) or Parallel ATA (PATA) hard disks, USB storage or the SCSI or parallel port version of the IOMEGA ZIP drive, say Y and read the SCSI-HOWTO, the Disk-HOWTO and the Multi-Disk-HOWTO, available from
drivers/ata/Kconfig +5 -0
@@ -17,6 +17,11 @@ menuconfig ATA that "speaks" the ATA protocol, also called ATA controller), because you will be asked for it. + NOTE: ATA enables basic SCSI support; *however*, + 'SCSI disk support', 'SCSI tape support', or + 'SCSI CDROM support' may also be needed, + depending on your hardware configuration. + if ATA config ATA_NONSTANDARD
Jeff Garzik
AppliedQuoted 16 lines · Randy Dunlap
Quoted 7 lines · On Mon, 11 Jun 2007 20:28:16 +0200 api wrote:
Good day,
When doing make menuconfig one comes acrossCONFIG_BLK_DEV_SD. The help file states that this is for scsi disks.NO MENTION IS MADE THAT IT IS NEEDE FOR SATA DISKS AS WELL!
Would have saved me a lot of time if the help was up to date. I hope this can be changed so others can make a kernel for sata systems quicker.From: Randy Dunlap <[email protected]>
Add help info for
BLK_DEV_SDreferring to its use in SATA or PATA driver configurations.
Quoted 8 lines
Add help text for "ATA" indicating that it probably needs some SCSI config symbols enabled in order to be useful.
Signed-off-by Randy Dunlap <[email protected]>--- drivers/ata/Kconfig | 5 +++++ drivers/scsi/Kconfig | 1 + 2 files changed, 6 insertions(+)
applied