Skip to contentSkip to conversation

Gericom Webboy Laptop Mouse/Touchpad

DISCUSSION Daniel Mierswa 2 participants 2 messages Jul 31, 2007

lore
Share & tools
lore
#0 lore raw

Hi there,
i'm having troubles getting my mouse and/or touchpad to work with 2.6.21.5 (and older ones). It's putting the following line into dmesg everytime the laptop gets lots of I/O or cpu load.
"psmouse.c: Wheel Mouse at isa0060/serio4/input0 lost synchronization, throwing 2 bytes away."
This happens for the touchpad and a newly brought PS/2 mouse. The cursor (be it gpm or X11) acts weird as in jumping around and clicking around without doing anything to it. As i searched about the string on google i found various tipps by removing ACPI (or even PM) from the kernel and retry. I've tried following setups:
No Power Management
ACPI
APM
other clocksources (pit, tsc, acpi_pm)
The problem still exists and seems to occur as i've mentioned on lots of disk i/o and/or cpu load.
This is a laptop which is not supported by the manufactur anymore (seems to be a Gericom Webboy). I would appreciate any tips to debug this further.
Please post back for any additional information you need.

Thanks in advance.

Signature · 2 lines
MfG
Mierswa, Daniel
#1 lore raw

Hi,

Quoted 7 lines · Daniel Mierswa

Hi there,
i'm having troubles getting my mouse and/or touchpad to work with 2.6.21.5 (and older ones). It's putting the following line into dmesg everytime the laptop gets lots of I/O or cpu load. "psmouse.c: Wheel Mouse at isa0060/serio4/input0 lost synchronization, throwing 2 bytes away."

This message is a wee bit too familiar to me as well, albeit for reasons different to that, I believe. :-$

Quoted 5 lines

The problem still exists and seems to occur as i've mentioned on lots of disk i/o and/or cpu load.
This is a laptop which is not supported by the manufactur anymore (seems to be a Gericom Webboy). I would appreciate any tips to debug this further. Please post back for any additional information you need.

Hmm, I'm pondering what I'd do here...
Could it be that you're using the "old" IDE layer (not libata yet) and hdparm -u or -d or -c is inconveniently set up?

Maybe run powertop to identify timer anomalies?
Try configuring a different CONFIG_HZ?
Or maybe run oprofile to try to figure out any abnormal system load? And did you try running a "barebone"-only configuration? Possibly some certain driver is causing this misbehaviour...
vmstat may provide some initial information as to what kind of activity exactly causes this issue.

Or maybe it's a simple X.org scheduling issue again?
What nice value do you run X.org at?
If it's too low, then maybe this causes the psmouse.c driver to have its mouse queue(?) processing get stuck and makes it have a hickup? In this context it would be good to ask about possible memory pressure on this system, too, since recently some people indicated more fluid X.org mouse pointer operation when mlocking the pointer handling code to avoid paging this code.

Oh, given that IIRC the Webboy is a slightly older Gericom model which thus may easily be a (somewhat hotter) P4 *desktop* CPU: could it be that you're hitting thermal emergency throttling on increased system activity? cat /proc/acpi/processor/*/throttling or something there might indicate this.

HTH,

Andreas Mohr