how to use 'eeprom read' command
Sachin Rane
Hi,
I want to read boot eeprom using u-boot.
Can you tell me which 'addr' I need to pass to the 'eeprom read' command?
--------------------------------------------------------------------------
=> help eeprom
eeprom read devaddr addr off cnt
eeprom write devaddr addr off cnt
- read/write cnt' bytes from devaddr EEPROM at offset off'
--------------------------------------------------------------------------
I want to access boot eprom which is at 'devaddr' 0x54 and offset '0' to '10'.
But I am not clear what ro pass for the 'addr' argument.
Regards,
Sachin Rane
Quoted 13 lines · Alphion Communications
Hi,
I want to read boot eeprom using u-boot.
Can you tell me which 'addr' I need to pass to the 'eeprom read' command?--------------------------------------------------------------------------
=> help eeprom
eeprom read devaddr addr off cnt
eeprom write devaddr addr off cnt
- read/writecnt' bytes fromdevaddrEEPROM at offsetoff'--------------------------------------------------------------------------
Quoted 7 lines
I want to access boot eprom which is at 'devaddr'
0x54and offset '0' to '10'.But I am not clear what ro pass for the 'addr' argument.
Regards,
Sachin Rane
IIRC, "addr" is the memory (RAM) address that you read the eeprom data into or is the source tow rite the eeprom data out. To read your i2c device 0x54, you would do something like:
eeprom read 54 0 0 10
and then would be able to see the 16 bytes of data with the md command:
md 0
Hope I'm not lying,
gvb
Quoted 8 lines · Jerry Van Baren
IIRC, "addr" is the memory (RAM) address that you read the eeprom data into or is the source tow rite the eeprom data out. To read your i2c device
0x54, you would do something like:eeprom read 54 0 0 10and then would be able to see the 16 bytes of data with the md command:
md 0Hope I'm not lying,
No, you are correct. But I would suggest to not use RAM address 0, because on some architectures the lower address range is reserved for exception vectors.
So please use:
=> eeprom read 54 100000 0 10
to read the first 16 (0x10) bytes to address 0x100000 (1MByte) in RAM.
Best regards,
Stefan
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de
=====================================================================