Skip to contentSkip to conversation

NOR flash partitions gone

DISCUSSION Sean MacLennan 3 participants 4 messages Feb 15, 2008

lore
Share & tools
lore
#0 lore raw

I did a git pull of Josh's for-2.6.25 tree. Now the NOR partitions are no longer setup.

				nor_flash@0,0 {
					compatible = "amd,s29gl032a", "cfi-flash";
					bank-width = <2>;
					reg = <0 0 400000>;
					#address-cells = <1>;
					#size-cells = <1>;
					partition@300000 {
						label = "fpga";
						reg = <300000 40000>;
					};
					partition@340000 {
						label = "env";
						reg = <340000 40000>;
					};
					partition@380000 {
						label = "u-boot";
						reg = <380000 80000>;
					};
				};

It still detects the chip, it just doesn't configure the partitions. Any ideas?

Cheers,
Sean

#1 lore raw
Quoted 24 lines · Sean MacLennan

I did a git pull of Josh's for-2.6.25 tree. Now the NOR partitions are no longer setup.

				nor_flash@0,0 {
					compatible = "amd,s29gl032a", "cfi-flash";
					bank-width = <2>;
					reg = <0 0 400000>;
					#address-cells = <1>;
					#size-cells = <1>;
					partition@300000 {
						label = "fpga";
						reg = <300000 40000>;
					};
					partition@340000 {
						label = "env";
						reg = <340000 40000>;
					};
					partition@380000 {
						label = "u-boot";
						reg = <380000 80000>;
					};
				};
Quoted 1 line

It still detects the chip, it just doesn't configure the partitions. Any ideas?

Try turning off command line partition support -- there's a bug in it that was exposed by changes to the OF physmap code (in particular, it returns -EINVAL rather than zero when no command line partitions are present).

-Scott

#2 lore raw
In reply to Sean MacLennan
Quoted 25 lines · Sean MacLennan

I did a git pull of Josh's for-2.6.25 tree. Now the NOR partitions are no longer setup.

				nor_flash@0,0 {
					compatible = "amd,s29gl032a", "cfi-flash";
					bank-width = <2>;
					reg = <0 0 400000>;
					#address-cells = <1>;
					#size-cells = <1>;
					partition@300000 {
						label = "fpga";
						reg = <300000 40000>;
					};
					partition@340000 {
						label = "env";
						reg = <340000 40000>;
					};
					partition@380000 {
						label = "u-boot";
						reg = <380000 80000>;
					};
				};
Quoted 2 lines

It still detects the chip, it just doesn't configure the partitions. Any ideas?

Probably CONFIG_MTD_OF_PARTS is not set?

Good luck,

Signature · 4 lines
Anton Vorontsov
email: [email protected]
backup email: [email protected]
irc://irc.freenode.net/bd2
#3 lore raw
Quoted 4 lines · Anton Vorontsov

Probably CONFIG_MTD_OF_PARTS is not set?

Good luck,

That was it! Thanks!

Cheers,
Sean