Skip to contentSkip to conversation

Pull Request for u-boot-mpc86xx.git

U-Boot-Users Jon Loeliger 2 participants 2 messages Feb 21, 2008 – Feb 22, 2008

lore
Share & tools
lore
#0 lore raw

Wolfgang,

I have now built, tested, debugged, and fixed a couple problems that were present in the v1.3.2-rc1 candidate for the MPC8610HPCD board. With these patchs below, both the MPC8610HPCD and MPC8641HPCN boards build and boot, and the sbc8641d builds (I can't test it).

Please pick these up for the v1.3.2 release.

Thanks,
jdl

The following changes since commit b6f29c84c208a091f95a10cbc9852d729659ba20:
Jean-Christophe PLAGNIOL-VILLARD (1):
s3c24x0: Fix unused variable 'i' in function 'serial_init_dev'

are available in the git repository at:

git://www.denx.de/git/u-boot-mpc86xx.git master

Jean-Christophe PLAGNIOL-VILLARD (2):

      mpc86xx: Fix implicit declaration of functions 'init_laws' and 'disable_l\

aw'
mpc86xx: Fix unused variable 'config' and 'immap'

Jon Loeliger (5):
86xx: Convert sbc8641d to use libfdt. 8610HPCD: Fix typos in two PCI setup registers. 8610HPCD: Don't use VIDEO/CFB_CONSOLE by default. 86xx: Fix GUR PCI config registers properly. 8610HPCD: Document the flashbank selection switches.

 board/freescale/mpc8610hpcd/mpc8610hpcd.c |    7 ++-
 board/freescale/mpc8641hpcn/mpc8641hpcn.c |   24 +++--------
 board/sbc8641d/sbc8641d.c                 |   41 +++++++++++++-------
 cpu/mpc86xx/Makefile                      |   17 ++++++--
 cpu/mpc86xx/cpu.c                         |   61 -----------------------------
 cpu/mpc86xx/cpu_init.c                    |    1 +
 cpu/mpc86xx/fdt.c                         |   35 ++++++++++++++++
 cpu/mpc86xx/spd_sdram.c                   |   10 +++--
 doc/README.mpc8610hpcd                    |    6 +++
 include/asm-ppc/immap_86xx.h              |   12 ++++--
 include/configs/MPC8610HPCD.h             |    2 +-
 include/configs/sbc8641d.h                |   10 +---
 12 files changed, 110 insertions(+), 116 deletions(-)
 create mode 100644 cpu/mpc86xx/fdt.c
#1 lore raw
Quoted 27 lines · In message <[email protected]> you wrote:

Wolfgang,

I have now built, tested, debugged, and fixed a couple problems that were present in the v1.3.2-rc1 candidate for the MPC8610HPCD board. With these patchs below, both the MPC8610HPCD and MPC8641HPCN boards build and boot, and the sbc8641d builds (I can't test it).

Please pick these up for the v1.3.2 release.

Thanks,
jdl

The following changes since commit b6f29c84c208a091f95a10cbc9852d729659ba20:
Jean-Christophe PLAGNIOL-VILLARD (1):
s3c24x0: Fix unused variable 'i' in function 'serial_init_dev'

are available in the git repository at:

git://www.denx.de/git/u-boot-mpc86xx.git master

Jean-Christophe PLAGNIOL-VILLARD (2):

      mpc86xx: Fix implicit declaration of functions 'init_laws' and 'disable_l\

aw'
mpc86xx: Fix unused variable 'config' and 'immap'

Quoted 6 lines

Jon Loeliger (5):
86xx: Convert sbc8641d to use libfdt. 8610HPCD: Fix typos in two PCI setup registers. 8610HPCD: Don't use VIDEO/CFB_CONSOLE by default. 86xx: Fix GUR PCI config registers properly. 8610HPCD: Document the flashbank selection switches.

Done, thanks.

Best regards,

Wolfgang Denk

Signature · 5 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
A stone was placed at a ford in a river with the inscription:
"When this stone is covered it is dangerous to ford here."