zImage corruption
Hi All,
I have been happily using buildroot for a while (thanks all its a great tool).
However I have started seeing a problem where the linux zImage being built gets corrupted and does not boot.
I am building a custom arm device using initramfs. If I checkout from clean and build it all works great and get a working zImage that is ~7.5MB. However if I then run make again I get a zImage file that is ~6.5MB and does not boot.
I have compared the root filesystems before and after calling make again and can see no difference. I have also tried doing a dirclean on the kernel and rebuilding and this still leads to a corrupt zImage.
Has anyone seen this before? Can anyone suggest what could be going on?
I can supply more config info if needed.
Thanks,
Will
Signature · 5 lines
------------------------------------------------------------------------ Will Wagner will_wagner at carallon.com Senior Project Engineer Office Tel: +44 (0)20 7371 2032 Carallon Ltd, Studio G20, Shepherds Building, Rockley Rd, London W14 0DA ------------------------------------------------------------------------
Hey Will,
I have similar troubles related to the rootfs created by buildroot, also on a custom ARM11 target. In my case, the Linux kernel is not able to start init (errors either -2, -8 or -14). In my case I had to replace the bin/ and etc/ directories with ones created outside in an (older) busybox directory.
The image sizes created by a "make" in buildroot vary greatly, sometimes there are 3 - 4 MB of space left in the image, sometimes only a few hundred kB.
cheers,
Christian
Quoted 23 lines · Will Wagner
Hi All,
I have been happily using buildroot for a while (thanks all its a great tool).
However I have started seeing a problem where the linux zImage being built gets corrupted and does not boot.
I am building a custom arm device using initramfs. If I checkout from clean and build it all works great and get a working zImage that is ~7.5MB. However if I then run make again I get a zImage file that is ~6.5MB and does not boot.
I have compared the root filesystems before and after calling make again and can see no difference. I have also tried doing a dirclean on the kernel and rebuilding and this still leads to a corrupt zImage.
Has anyone seen this before? Can anyone suggest what could be going on?
I can supply more config info if needed.
Thanks,
Will