Lifeview flydvb-t duo min pci
Hi Bart,
Am Montag, den 24.03.2008, 21:03 +0100 schrieb Bart Michiels:
Quoted 3 lines
Hello,
I found your emailadress in the mailinglist on video4linux
thanks for your report, but better post to the lists.
We must have it there anyhow, also possible patches and if I'm in delay, like currently, somebody else of the group might have picked it up already.
Quoted 2 lines
I have a problem with my flydvb-t duo mini pci card. It provides analog tv and digital tv (dvb-t).
There is another PCI Mini seen on Asus W2 laptops with the same PCI subsystem, but comes up with gpio init 0x50000 and has several different bytes in the eeprom, they also seem to indicate that this one has two tuners (DUO), but yours rather has only one (HYBRID).
Quoted 2 lines
The flydvb-t duo mini pci is an OEM model that is included in the Medion MD95500 notebook from 3 years ago
Yes, remember we tried to look this up.
Quoted 2 lines
It never autodetect because it is not in the saa7134 cardlist
the ID is 5168 0307
Yes, not in saa7134-cards.c auto detection yet.
Quoted 10 lines
I donwloaded the lastest sourcode of v4L on the site.
I compiled it without changing anything and now i can get my card working.After every reboot i have load it manually.
Sudo rmmod saa7134-alsa
Sudo rmmod saa7134-dvb
Sudo rmmod saa7134
Sudo rmmod tuner
Quoted 5 lines
when i removed this module i load card 94
sudo modprobe saa7134 card=94 i2c_scan=1
Now my card is working but it is not very stable sometimes my linux hangs
That later by Hartmut added card has the special, to switch on a saa713x gpio pin from analog to digital, but others don't report problems.
Quoted 33 lines
My dmesg output with my working card:
[ 126.916000] saa7130/34: v4l2 driver version 0.2.14 loaded [ 126.916000] saa7133[0]: found at 0000:06:03.0, rev: 208, irq: 19, latency: 181, mmio: 0xb4007800 [ 126.916000] saa7133[0]: subsystem: 5168:0307, board: LifeView FlyDVB-T Hybrid Cardbus/MSI TV @nywhere A/D NB [card=94,insmod option] [ 126.916000] saa7133[0]: board init: gpio is 10000 [ 127.068000] saa7133[0]: i2c eeprom 00: 68 51 07 03 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 [ 127.068000] saa7133[0]: i2c eeprom 10: 00 00 62 08 ff 20 ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom 20: 01 40 01 03 03 01 01 03 08 ff 01 e7 ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom 40: ff 24 00 c2 96 10 05 01 01 16 22 15 ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff
Quoted 8 lines
ff ff ff ff ff ff
[ 127.068000] saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.068000] saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 127.076000] saa7133[0]: i2c scan: found device @ 0x10 [???]
tda10046 digital demodulator
Quoted 1 line
[ 127.092000] saa7133[0]: i2c scan: found device @ 0x96 [???]
analog demodulator and i2c gate for analog tuning
Quoted 3 lines
[ 127.100000] saa7133[0]: i2c scan: found device @ 0xa0 [eeprom] [ 127.196000] tuner' 0-004b: chip found @ 0x96 (saa7133[0]) [ 127.276000] tda829x 0-004b: setting tuner address to 61
tuner at 0x61, 7bit notation
Quoted 1 line
[ 127.340000] tda829x 0-004b: type set to tda8290+75
old not hybrid tda8275 tuner, Hmm !
Quoted 13 lines
[ 132.028000] saa7133[0]: registered device video0 [v4l2] [ 132.028000] saa7133[0]: registered device vbi0 [ 132.028000] saa7133[0]: registered device radio0 [ 132.112000] saa7134 ALSA driver for DMA sound loaded [ 132.112000] saa7133[0]/alsa: saa7133[0] at 0xb4007800 irq 19 registered as card -2 [ 133.432000] DVB: registering new adapter (saa7133[0]) [ 133.432000] DVB: registering frontend 0 (Philips TDA10046H DVB-T)... [ 133.532000] tda1004x: setting up plls for 48MHz sampling clock [ 135.532000] tda1004x: found firmware revision 29 -- ok
Quoted 5 lines
The dvb-t is working now but i did not test the analog part.
I also think there some errors:
[ 127.076000] saa7133[0]: i2c scan: found device @ 0x10 [???] [ 127.092000] saa7133[0]: i2c scan: found device @ 0x96 [???]
That is OK. We need debug and reports for the analog part too.
Quoted 9 lines
and on the net most card have normal gpio number , my card hasn't now
[ 126.916000] saa7133[0]: board init: gpio is 10000Is it possible to add this card to the saa7134 driverlist?
I really hope so.
I already tried to add the card in thecardlist.cand in the documentation and i compiled. the card is recognized but it doesn't work. I also tried to change the already added card 5168 3307 into 5168 0307 but i doens't work either.
Should work, a saa7133 device and 5168:0307 is not in use yet.
Quoted 3 lines
Sounds very strange.
I hope you or the community can do something with this information to support this card too
Yes, but there is not any reason for failing auto detection, but we must at first investigate also the analog tuning.
Cheers,
Hermann
--
video4linux-list mailing list
Unsubscribe mailto:[email protected]?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list