smc91x: remove "irq_flags" from "struct smc91x_platdata"
Subsystems (3)
PATCH 2/8 smc91x: remove "irq_flags" from "struct smc91x_platdata"
IRQ trigger type can be specified in the IRQ resource definition by IORESOURCE_IRQ_*, we need only one way to specify this.
This also fixes the following small issue:
To allow dynamic support for multiple platforms, when those relevant macros are not defined for one specific platform, the default case will be:
- SMC_DYNAMIC_BUS_CONFIG defined
- and SMC_IRQ_FLAGS = IRQF_TRIGGER_RISING
While if "irq_flags" is missing when defining the smc91x_platdata, usually as follows:
static struct smc91x_platdata xxxx_smc91x_data = {
.flags = SMC91X_USE_XXBIT,};
The lp->cfg.irq_flags will always be overriden by the above structure (due to a memcpy), thus rendering lp->cfg.irq_flags to be "0" always. (regardless of the default SMC_IRQ_FLAGS or IORESOURCE_IRQ_* flags)
Fixes this by forcing to use IORESOURCE_IRQ_* flags if present, and make the only user of smc91x_platdata.irq_flags (renesas/migor) to use IORESOURCE_IRQ_*.
--- arch/sh/boards/renesas/migor/setup.c | 3 +-- drivers/net/smc91x.c | 9 +++++---- include/linux/smc91x.h | 1 - 3 files changed, 6 insertions(+), 7 deletions(-)
arch/sh/boards/renesas/migor/setup.c +1 -2
@@ -30,7 +30,6 @@static struct smc91x_platdata smc91x_info = { .flags =SMC91X_USE_16BIT , - .irq_flags =IRQF_TRIGGER_HIGH , };static struct resource smc91x_eth_resources[] = {
@@ -42,7 +41,7 @@ static struct resource smc91x_eth_resources[] = { }, [1 ] = { .start =32 ,/* IRQ0 */ - .flags =IORESOURCE_IRQ , + .flags =IORESOURCE_IRQ |IORESOURCE_IRQ_HIGHLEVEL , }, };
drivers/net/smc91x.c +5 -4
@@ -2105,6 +2105,7 @@ static int smc_drv_probe(struct platform_device *pdev)struct net_device *ndev;struct resource *res, *ires;unsigned int __iomem *addr; +unsigned long irq_flags =SMC_IRQ_FLAGS ;int ret; res =platform_get_resource_byname (pdev,IORESOURCE_MEM ,"smc91x-regs" );
@@ -2134,7 +2135,6 @@ static int smc_drv_probe(struct platform_device *pdev)*/ lp =netdev_priv (ndev); - lp->cfg.irq_flags =SMC_IRQ_FLAGS ;#ifdef SMC_DYNAMIC_BUS_CONFIG if (pd)
@@ -2159,8 +2159,9 @@ static int smc_drv_probe(struct platform_device *pdev) } ndev->irq = ires->start; -if (SMC_IRQ_FLAGS ==-1 ) - lp->cfg.irq_flags = ires->flags &IRQF_TRIGGER_MASK ; + +if (ires->flags &IRQF_TRIGGER_MASK ) + irq_flags = ires->flags &IRQF_TRIGGER_MASK ; ret =smc_request_attrib (pdev);if (ret)
@@ -2187,7 +2188,7 @@ static int smc_drv_probe(struct platform_device *pdev) }#endif - ret =smc_probe (ndev, addr, lp->cfg.irq_flags); + ret =smc_probe (ndev, addr, irq_flags);if (ret !=0 ) goto out_iounmap;
include/linux/smc91x.h +0 -1
@@ -7,7 +7,6 @@struct smc91x_platdata {unsigned long flags; -unsigned long irq_flags;/* IRQF_... */ };#endif /* __SMC91X_H__ */
Signature · 1 line
1.5.4.3
Quoted 24 lines · Eric Miao
IRQ trigger type can be specified in the IRQ resource definition by IORESOURCE_IRQ_*, we need only one way to specify this.
This also fixes the following small issue:
To allow dynamic support for multiple platforms, when those relevant macros are not defined for one specific platform, the default case will be:
-
SMC_DYNAMIC_BUS_CONFIGdefined
- andSMC_IRQ_FLAGS=IRQF_TRIGGER_RISINGWhile if "
irq_flags" is missing when defining thesmc91x_platdata, usually as follows:static struct smc91x_platdata xxxx_smc91x_data = { .flags = SMC91X_USE_XXBIT,};
The
lp->cfg.irq_flagswill always be overriden by the above structure (due to a memcpy), thus renderinglp->cfg.irq_flagsto be "0" always. (regardless of the defaultSMC_IRQ_FLAGSor IORESOURCE_IRQ_* flags)
Quoted 5 lines
Fixes this by forcing to use IORESOURCE_IRQ_* flags if present, and make the only user of smc91x_platdata.irq_flags (renesas/migor) to use IORESOURCE_IRQ_*.
Signed-off-by Eric Miao <[email protected]>
Quoted 83 lines
--- arch/sh/boards/renesas/migor/setup.c | 3 +-- drivers/net/smc91x.c | 9 +++++---- include/linux/smc91x.h | 1 - 3 files changed, 6 insertions(+), 7 deletions(-)arch/sh/boards/renesas/migor/setup.c +1
-2@@ -30,7 +30,6 @@static struct smc91x_platdata smc91x_info = { .flags =SMC91X_USE_16BIT , - .irq_flags =IRQF_TRIGGER_HIGH , };static struct resource smc91x_eth_resources[] = {@@ -42,7 +41,7 @@ static struct resource smc91x_eth_resources[] = { }, [1 ] = { .start =32 ,/* IRQ0 */ - .flags =IORESOURCE_IRQ , + .flags =IORESOURCE_IRQ |IORESOURCE_IRQ_HIGHLEVEL , }, };drivers/net/smc91x.c +5
-4@@ -2105,6 +2105,7 @@ static int smc_drv_probe(struct platform_device *pdev)struct net_device *ndev;struct resource *res, *ires;unsigned int __iomem *addr; +unsigned long irq_flags =SMC_IRQ_FLAGS ;int ret; res =platform_get_resource_byname (pdev,IORESOURCE_MEM ,"smc91x-regs" );@@ -2134,7 +2135,6 @@ static int smc_drv_probe(struct platform_device *pdev)*/ lp =netdev_priv (ndev); - lp->cfg.irq_flags =SMC_IRQ_FLAGS ;#ifdef SMC_DYNAMIC_BUS_CONFIG if (pd)@@ -2159,8 +2159,9 @@ static int smc_drv_probe(struct platform_device *pdev) } ndev->irq = ires->start; -if (SMC_IRQ_FLAGS ==-1 ) - lp->cfg.irq_flags = ires->flags &IRQF_TRIGGER_MASK ; + +if (ires->flags &IRQF_TRIGGER_MASK ) + irq_flags = ires->flags &IRQF_TRIGGER_MASK ; ret =smc_request_attrib (pdev);if (ret)@@ -2187,7 +2188,7 @@ static int smc_drv_probe(struct platform_device *pdev) }#endif - ret =smc_probe (ndev, addr, lp->cfg.irq_flags); + ret =smc_probe (ndev, addr, irq_flags);if (ret !=0 ) goto out_iounmap;include/linux/smc91x.h +0
-1@@ -7,7 +7,6 @@struct smc91x_platdata {unsigned long flags; -unsigned long irq_flags;/* IRQF_... */ };#endif /* __SMC91X_H__ */ Signature · 1 line
1.5.4.3
Nicolas